CWNA-108 Exam Dumps - Certified Wireless Network Administrator

Shared Key Authentication is a security solution that was defined in the original 802.11 standard as an alternative to Open System Authentication, which does not provide any security at all. Shared Key Authentication uses WEP (Wired Equivalent Privacy) to encrypt and authenticate data frames between the client station and the AP. However, WEP has been proven to be extremely vulnerable to various attacks that can easily crack the encryption key and compromise the network security. Therefore, Shared Key Authentication is deprecated in the 802.11 standard and should never be used in any modern WLAN deployment . References: [CWNA-109 Study Guide], Chapter 10: Wireless LAN Security, page 401; [CWNA-108 Study Guide], Chapter 10: Wireless LAN Security, page 391; [Wikipedia], Wired Equivalent Privacy.

Sensors should be deployed in critical areas where WLAN performance must be high for best results when using a WLAN monitoring solution that utilizes distributed sensor devices. A WLAN monitoring solution is a system that collects, analyzes, and reports on the status and performance of a WLAN. A WLAN monitoring solution can use different methods to gather data from the WLAN, such as embedded software agents, external hardware probes, or distributed sensor devices. Distributed sensor devices are dedicated devices that are deployed throughout the WLAN coverage area to monitor the wireless traffic and environment. Distributed sensor devices can perform various functions, such as scanning the spectrum, capturing wireless frames, measuring signal quality, detecting rogue access points, testing connectivity, and generating alerts. Distributed sensor devices can provide more accurate and comprehensive data than other methods, but they also require more planning and deployment costs. Therefore, it is important to deploy sensors strategically in critical areas where WLAN performance must be high, such as high-density zones, high-priority applications, or high-security locations. By deploying sensors in critical areas, the WLAN monitoring solution can ensure optimal WLAN performance and reliability in those areas and identify and resolve any issues or problems that may arise. The other options are not the best places to deploy sensors for best results. Deploying sensors in switching closets is not effective because sensors need to be close to the wireless medium to monitor it properly. Deploying sensors every 5 meters and alongside each AP is not efficient because sensors may overlap or interfere with each other and cause unnecessary redundancy or complexity. Deploying sensors above the plenum on each floor is not practical because sensors may not capture the wireless traffic and environment accurately due to attenuation or reflection from the ceiling materials or objects. References: CWNA-109 Study Guide, Chapter 14: Troubleshooting Wireless LANs, page 4831

DHCP (Dynamic Host Configuration Protocol) is the network service where option 43 must be configured to allow access points to locate controllers. DHCP is a protocol that allows a device to obtain an IP address and other network configuration parameters from a server. In a wireless controller scenario, the access points can use DHCP to request an IP address from a DHCP server, which can also provide the IP address or hostname of the wireless controller as an option in the DHCP response. Option 43 is a vendor-specific option that can be used to encode custom information for different types of devices. For example, Cisco access points can use option 43 to receive the IP address of the wireless controller from the DHCP server, while Aruba access points can use option 43 to receive the hostname of the wireless controller from the DHCP server. This way, the access points can discover the wireless controller and establish a connection with it. References: 1, Chapter 8, page 309; 2, Section 5.2

A possible cause of a sudden change in performance for the laptop computers is that a new tenant in the building has set their AP to the same RF channel that your customer is using. This can create co-channel interference (CCI), which is a situation where two or more APs or devices use the same or overlapping channels in the same area. CCI can degrade the performance of WLANs by increasing contention, collisions, retransmissions, and latency. CCI can also reduce the effective range and throughput of WLANs by lowering the signal-to-noise ratio (SNR). To avoid or mitigate CCI, it is recommended to use non-overlapping channels, adjust transmit power levels, or implement channel management techniques such as dynamic frequency selection (DFS) or load balancing. The sky condition, antenna position, or Bluetooth headset are not likely to cause a sudden change in performance for the laptop computers. References: [CWNP Certified Wireless Network Administrator Official Study Guide: Exam CWNA-107], page 81; [CWNA: Certified Wireless Network Administrator Official Study Guide: Exam CWNA-106], page 71.

The two IEEE amendments that should be supported to provide the management frame protection and fast secure roaming security features are 802.11r and 802.11w12.

• 802.11r (Fast BSS Transition): This amendment to the IEEE 802.11 standard permits continuous connectivity aboard wireless devices in motion, with fast and secure client transitions from one Basic Service Set to another1.
• 802.11w (Management Frame Protection): This amendment increases the security of its management frames2.

A laptop-based spectrum analyzer with a directional antenna is the best solution for locating a non-802.11 device that is suspected of causing interference on the WLAN. A spectrum analyzer is a device or a software application that can measure and display the frequency spectrum of electromagnetic signals in a given range. A spectrum analyzer can show the amplitude, frequency, bandwidth, modulation, and other characteristics of different signals in the spectrum, which can help identify their sources and types. A spectrum analyzer can also detect non-802.11 devices that may cause interference on the WLAN, such as microwave ovens, cordless phones, Bluetooth devices, or radar systems. A laptop-based spectrum analyzer is a software application that runs on a laptop computer and uses an external USB adapter as its RF interface. A laptop-based spectrum analyzer has the advantage of being portable, flexible, and cost-effective compared to a hardware-based spectrum analyzer. A directional antenna is an antenna that radiates or receives RF signals more strongly in one direction than in others. A directional antenna has a high gain and a narrow beamwidth, which means it can focus the RF energy in a specific direction and reduce the interference from other directions. A directional antenna can also increase the range and sensitivity of the RF signal detection. To locate a non-802.11 device that is causing interference on the WLAN, a laptop-based spectrum analyzer with a directional antenna can be used to perform a technique called RF hunting or triangulation. This technique involves pointing the directional antenna in different directions and observing the signal strength and characteristics of the interfering device on the spectrum analyzer. By moving around and changing the direction of the antenna, the location of the interfering device can be estimated based on where the signal strength is highest and most consistent. References: 1, Chapter 7, page 282; 2, Section 4.3

The client STA can use Beacon frames transmitted by the AP to verify that an AP supports the same data rates that it supports. Beacon frames are management frames that are periodically broadcasted by the APs to announce their presence, capabilities, and parameters. One of the information elements contained in the Beacon frames is the Supported Rates or Extended Supported Rates, which lists the data rates that the AP can use for communication. The client STA can compare its own data rates with those advertised by the AP to determine if they are compatible. Data frames, authentication frames, and probe request frames do not contain information about data rates. References: [CWNP Certified Wireless Network Administrator Official Study Guide: Exam CWNA-107], page 133; [CWNA: Certified Wireless Network Administrator Official Study Guide: Exam CWNA-106], page 123.