Note! Following H12-211 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

H12-211 Exam Dumps - HCIA-Routing & Switching V2.5 Exam

Go to page:

<< First
Prev
2
3
4
5
6
7
8
9
10
11
Next
Last >>

Question # 49

In terms of security, tunnel mode is more secure than the transport mode.

TRUE

FALSE

Full Access

Question # 50

Refer to the graphic, which of the following statement are true about VLAN configuration on Huawei Switches?

Client 1 belongs to VLAN 10 and the VLAN assignment command on LSW1 is correct

Client 2 belongs to VLAN 20 and the MAC address based VLAN assignment command on LSW1 is correct

Client 3 belongs to VLAN 30 and the VLAN assignment command on LSW1 is correct

Client 4 belongs to VLAN 40 and the VLAN assignment command on LSW1 is correct

Full Access

Question # 51

When the IPsec data encapsulation mode is tunnel mode, the IP address of the intranet host is hidden. In this way the security of the entire original data packet is protected.

TRUE

FALSE

Full Access

Question # 52

Which of the following statements regarding single area OSPF are correct

An IP address needs to be configured on a loopback interface of each router before configuring on OSPF area

The value of an area can be from 0.0.0.0 to 255.255.255.255

A single area can be configured using any supported area number

All of the links of the network need to be advertised in Area 0

Full Access

Question # 53

Which of the following technologies is used to bind MAC addresses to interface on a switch

SEP

Port security

ACL

NAT

Full Access

Question # 54

Which of the following information must be configured for a DHCPv6 relay agent?

DHCPv6 DUID

IPv6 address of the DHCPv6 server

DHCPv6 address pool

DNS server address

Full Access

Question # 55

Which of the following statements are true about the dynamic MAC address table?

After a device is reset , an interfaces card is hot swapped , or an interface card is reset , the saved entries on the device or interface card are not lost.

Dynamic MAC address entries are obtained by learning the source MAC addresses of packets received by an interface, and can be aged out.

After a device is rest , an interface card is hot swapped or an interface card is reset dynamic MAC address entries on the device or interface card are lost.

You can obtain the number of users communicating on an interface by checking the number of specified dynamic address MAC address entries.

Full Access

Question # 56

If the value of the "Type/Length" field of an Ethernet data frame is 0x0800, the length range of the upper - layer packet header carried by the data frame is from 20B to 60B.

TRUE

FALSE

Full Access

Go to page: