Note! Following H12-261 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

H12-261 Exam Dumps - HCIE-Routing & Switching (Written)

Go to page:

<< First
Prev
1
2
3
4
5
6
7
8
9
10
Next
Last >>

Question # 17

Which of the following statements is true regarding the domain-authentication-mode md5 hello command in the IS_IS process?

This command enables 1S-IS Hello PDUs to carry authentication information.

1S-1S SNP and LSP can be flooded normally only when the domain authentication mode and password of all routers in the same routing domain are MD5 and hello.

IS-IS authentication cannot be applied to IPv6 environments.

Routing domain authentication enables Level-1 and Level-2 SNPs and LSPs to carry authentication information.

Full Access

Question # 18

The function of the HoP Limit field in an IPv6 header is similar to the function of which field in an IPv4 header?

Protocol

Time to Live

Flags

Identification

Full Access

Question # 19

Which of the following statements regarding BGP load balancing are false?

The AS_Path attribute values of equal-cost routes for load balancing must be different.

When BGP load balancing is implemented, the local device can change the next-hop address of routes to its own address when advertising the routes to IBGP peer groups only if the peer next-hop-local command is configured.

Load balancing can be implemented among BGP routes with different origins but having the same destination network segment.

Load balancing can be implemented among IBGP routes and EBGP routes having the same destination on the public network.

Full Access

Question # 20

Which of the following attributes cannot be directly referenced by the if-match clause of route-policies?

Community-filter

IP-prefix

AS-Path-filter

Regular expression

Full Access

Question # 21

The figure shows the topology and configuration. Which of the following method, can he used to exclude the specific route .0.0.3.3/32 from the routing table of R1?

Configure route summarization on R2 and summarize routes as 10.0.0.0/16.

Configure route summarization on R3 and summarize routes as 10.0.0.0/16.

On R1, configure a filter policy, use the ACL applied to the filter-policy to match 10.0.3.3/32, and apply direction.

Full Access

Question # 22

Which of the following statements regarding the Multi-VPN-instance CE (MCE) is false?

An MCE device creates a routing table for each VPN and binds each VPN instance to itâ€™s interfaces

The MCE has been bound to a VPN. Therefore, no VPN needs to be bound to the PE connected to the MCE

Based on the interface for receiving routing information, the MCE determines the origin of the routing information and adds the routing information to the routing table of the corresponding VPN

The MCE can connect to multiple VPNs. The MCE solution isolates services of different VPNs while reducing the cost of network devices

Full Access

Question # 23

Assume R1 and R2 have a valid level-2 ISIS peering for IPv6 and the additional configuration shown is applied. Which of the following statements about routing entries on R2 are true?