Note! Following H12-261 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

H12-261 Exam Dumps - HCIE-Routing & Switching (Written)

Go to page:

<< First
Prev
1
2
3
4
5
6
7
8
9
10
Next
Last >>

Question # 57

The network administrator can use the CAR CAR technology in the traffic management. Which of the following techniques can be used during surgery?

Double barrel double speed

Single barrel speed

Three barrels

Double barrel speed single

Full Access

Question # 58

The following is about reliability, describing LDP errors?

The LDP FRR LSP LSP can also be generated from the mapping of the non-lowest hops as the privilege label, and the primary device is configured as the primary device. The table forwarding entry B. LDP IGP IGP LDP IGP is associated with the association. , guaranteed to be consistent with the path

Hand-configured dynamic LDP FRR 32 LDP LSP policy is the default route to the backup device.

LDP GR (Graceful Restart) MPLS uses the feature that the plane and the control plane are separated, and is forwarded when the device protocol is replaced by the restart or the primary or the reverse.

No interruption.

Full Access

Question # 59

BGP BGP introduces other post-routing protocols. The next hop in the routing table is consistent with the next hop of the redistributed route.

Correct

Error

Full Access

Question # 60

The router passes two parallel cables and two EPE serial neighbors. What method do you use to implement the cable in two parallels?

Two EBGP of the connection? Two-way sharing of the neighbor load

Use the interface to establish a relationship and configure Loopback EBGP EBGP Multi--hop, Loopback, IGP neighbor configuration interface as the update source for

The equivalent load of the address is used to share the load between the implementations.

Without any method, the traffic will be shared by different autonomous systems on the available roads, and the BGP dynamic chain will realize the inter-system load.

Use the command "ebgp-load-balance" at both ends

Configure Loopback EBGP with the interface as the update source. AS IGP EBGP is the neighbor relationship. Each of the two neighbor rings that arrive at the home address is required.

Price path and need to use the command; "next-hop-local"

Configure the loopback EBGP with the interface as the update source. AS IGP EBGP is the neighbor relationship. Each neighbor ring that needs to arrive at the home loop address is required.

Equivalent path and need to use the command and ; "ebgp-max-hop "next-hop-local

Full Access

Question # 61

If the PIM-SM is running in the broadcast network, the forwarding tree needs to be set up between the broadcast source and the receiver to enable the receiver to receive the broadcast data set.

Then for the group forwarding tree option, the following is the correct description of the built broadcast? Multiple ( )

The RP RPT is constructed with the recipient.

The multicast source and the RP RPT are constructed by the tree.

RP SPT and the recipient's construction is the tree

The multicast source and the RP SPT are constructed by the tree.

Full Access

Question # 62

In which port can provide a copy of the path to the generated root point RSTP sufficient tree section? What is the port?

Alternate Learning port and status

Alternate Forwarding Port and Status

Root port and shape Listening state

Designate Listening port and status

Alternate Discarding port and status

Full Access

Question # 63

If more than one candidate group is selected for RP RP RP ( ) in a broadcast, the election of multiple candidates from the multiple candidates is more selective than the following parameters.

C-RP's priority

The mask of the C-RP service that matches the address of the added group.

Address of the C-RP IP interface

Number of the C-RP interface

Full Access

Question # 64

In the following topology diagram, all the interfaces of the router are all open. Figure ISIS ( ), the following methods are correct.