New Year Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

H12-322 Exam Dumps - Huawei Certified ICT Professional - Wireless Local Area Network- Planning and Optimizing Enterprise WLAN

Go to page:
Question # 17

In the indoor BYOD scene, which of the following is the edge RSSI value of the key area?

A.

-45dBm

B.

-55dBm

C.

-65dBm

D.

-75dBm

Full Access
Question # 18

WLAN engineers need to test the actual attenuation values ​​of different channels in an obstacle in the room. Which of the following steps is correct?

1. Configure the 2.4G and 5G signals of the fat AP, place and turn on the signal source.

2. Select the obstacle to be tested

3. Using the signal scanning tool, test the field strength of the signal on both sides of the obstacle.

4. The subtraction of the two can calculate the attenuation value of the obstacle.

A.

1234

B.

2143

C.

1324

D.

2134

Full Access
Question # 19

Which of the following APs supports MIMO 3*3 technology?

A.

AP6010DN

B.

AP5010DN

C.

AP6010SN

D.

AP7110DN

Full Access
Question # 20

Which of the following are the areas of interest for a WLAN survey outdoor bridge scenario?

A.

The transmission path of the bridge link is occluded, marking the latitude and longitude of the station.

B.

Observe the AP and antenna installation method for the site.

C.

Every site needs to pay attention to the location of the weak house

D.

Whether to add a relay between the leaf site and the aggregation site

Full Access
Question # 21

Which of the following statements about the merge path of the WLAN Tester 2.0 tool is correct?

A.

For the same drawing node, multiple, multiple tested paths can be merged

B.

At least 2 and above paths can be merged

C.

The path where the calculation fails occurs, and the path that failed the calculation is automatically deleted after the path is merged.

D.

The merged path cannot be merged again

Full Access
Question # 22

Which of the following is true about the WLAN Survey Pad tooling method?

A.

Supporting finger operations during the process of drawing obstacles, moving the scaled drawings to find the best position to draw obstacles, does not support increasing obstacle types

B.

The industrial survey tools and planning tools need to be used together. First, get the drawings, first use the planning tools to make a simple plan for the project, and then take the Pad to the present.

Work on the site, then export the project and import it into the planning tool for further planning.

C.

Create a new project, select the floor node, see the corresponding building thumbnail in the preview box on the right, click on the thumbnail to enter the selected floor to supplement the survey information.

D.

Pad's industrial survey tools and planning tools are suitable for pre-sales network regulations, and WLAN test tools are used for post-production verification before delivery.

Full Access
Question # 23

Which of the following options are inherent properties of the antenna?

A.

Horizontal lobes, vertical lobes

B.

Downtilt angle

C.

Azimuth

D.

Gain

Full Access
Question # 24

If the fields To DS and From DS in the frame are both 0, which of the following is the data frame?

A.

Ad-hoc

B.

AP

C.

Client

D.

Wireless bridge

Full Access
Go to page: