Note! Following HPE6-A46 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

HPE6-A46 Exam Dumps - Delta - Implementing Aruba Campus Switching Solutions

Go to page:

Question # 9

A network administrator wants to use Aruba AirWave to audit an AOS-Switch configuration. What is one requirement?

The switch defines the AirWave IP address in its zero touch provisioning (ZTP) profile.

The switch specifies the AirWave IP address for the RADIUS server used for Telnet and SSH authentication.

The switch is authorized in AirWave, which has the correct credentials to log in as a CLI manager.

The switch is set to Manage Read-Write mode in AirWave but is not set to Monitor Only + Firmware Updates.

Full Access

Question # 10

Refer to the exhibit.

The routing switches shown in the exhibit use OSPF, and all of their interfaces are in Area 1. A faulty link on Switch-1 went up and down many times over the course of several hours. This caused link state updates (LSUs) to flood all of the routing devices in the OSPF AS and reduce performance. The network administrator fixed the faulty link on Switch-1, but the administrator also wants to mitigate the effects if a similar issue occurs in the future.

Which design improvement would help?

Configure Area 1 as a stub area on all routers except Switch-2, Switch-3, and Switch-4

Divide the AS into different areas, and aggregate routes between them

Divide the AS into different areas, and configure the backbone area as an NSSA

Decrease the LSA generation timer, and make sure to set the same value on all routers

Full Access

Question # 11

An AOS-Switch has type of service disabled on it globally. The administrator enters:

AOS-Switch(config)# interface 1 qos trust device aruba-ap

What is the effect of this command?

if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to prioritize traffic sent on interface 1

if interface 1 connects to an Aruba AP, it uses the incoming DSCP and a global DSCP map to prioritize traffic received on this interface

if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to classify traffic received on interface 1

if interface 1 connects to an Aruba AP, the switch marks all traffic received on the interface with a higher than default priority value

Full Access

Question # 12

Refer to the exhibit.

A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the companyâ€™s requirements?

The proposed switches should be replaced with switches such as the Aruba 2930M to support the backplane stacking technology.

VRRP should be implemented instead of backplane stacking to support the Layer 3 redundancy requirements.

Link aggregations should be established without LACP to support the Layer 2 redundancy requirements and backplane stacking limitations.

The proposed switches should be replaced with switches that support VSF to support the required distance between stack members.

Full Access

Question # 13

Refer to the exhibits.

Exhibit 1

Exhibit 2

A company has attempted to implement OSPF without success. The devices in Area 1 need to be able to reach Area 2. Routes should be aggregated for advertisement in other areas. What must be changed to meet these requirements?

Change Area 3 to Area 0; remove Area 1 from Switch-2 and Area 2 from Switch-1.

Move the 10.1.0.0/16 range to Area 2 on Switch-1 and the 10.2.0.0/16 range to Area 1 on Switch-2.

Add Area 1 and Area 2 on VLAN 100 on both Switch-1 and Switch-2. Remove Area 3.

Add the 10.2.0.0/16 range on Switch-1 and the 10.1.0.0/16 range on Switch-2.

Full Access

Question # 14

Refer to the exhibit.