Note! Following JN0-663 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is JN0-664

JN0-663 Exam Dumps - Service Provider Routing and Switching. Professional (JNCIP-SP)

Go to page:

Question # 9

Exhibit.

Referring to the exhibit, which statement is true?

The BGP session between R1 and R2 will fail to establish correctly due to an NLRI mismatch

The BGP session between R1 and R2 will establish correctly and the met unicast and the met6 unicast NLRIs will pass routing information

The BGP session between R1 and R2 will establish correctly and only the inet6 unicast NLRI will pass routing information

The BGP session between R1 and R2 will establish correctly and only the met unicast NLRI will pass routing information

Full Access

Question # 10

Exhibit:

Traffic is being sent from R2 to R3. The link between R2 and R3 fails.

Referring to the exhibit, which statement is correct?

Traffic will automatically reroute using the shortest path, which is R2 to R1 to R3.

Traffic will automatically reroute using R2 to R4 to R1 to R3.

Manual intervention is required for traffic to be rerouted.

Traffic will automatically reroute distributed between all available paths.

Full Access

Question # 11

Exhibit:

You are troubleshooting an issue where R1 is no longer receiving the default IS-IS route from R3.

Referring to the exhibit, which action would you take to solve the problem?

Delete the protocols isis ignore-attached-bit configuration statement on R3.

Delete the protocols isis import configuration statement on R1.

Delete the protocols isis level 2 disable configuration statement on R3.

Delete the protocols isis ignore-attached-bit configuration statement on R1.

Full Access

Question # 12

Exhibit.

Two CE devices (CE-1 and CE-2) belong to the same customer and connect into a single PE device (PE-1) However, the CE devices cannot communicate with each other You want to allow the CE devices to communicate with each other

Referring to the exhibit, which action would solve the problem?

Configure both routing instances with the set routing-opt ions auto-export-statement

Configure both routing instances with the set routing-options autonomous-system loops 3 statement

Configure both routing instances with the vrf-table-label statement

Configure both routing instances with the as-override statement within the BGP protocol

Full Access

Question # 13

Which statement is correct about BGP FlowSpec between a service provider's PE router and a customer?

The NLRI received from a customer is stored in the flowspec. inet .0 table.

The RFC deterministic traffic filtering algorithm is used by default in Junos.

The flow routes received from a customer are limited to /32 masks for IPv4.

The NLRI received from a customer is stored in the inetfiow.0 table

Full Access

Question # 14

Exhibit:

The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer 2 VPN that uses the BGP session are unable to communicate.

What is the problem in this situation?

The BGP peer does not support the restarter functionality.

The local BGP router does not support Layer 2 VPN and Layer 3 VPN NLRI address families at the same time.

There is a mismatch in the supported NLRI address families between the BGP peers.

The BGP peer does not support the add-path feature.

Full Access

Go to page: