Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

Note! Following JN0-682 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is JN0-683

JN0-682 Exam Dumps - Data Center Professional (JNCIP-DC)

Go to page:
Question # 17

Referring to the exhibit,

you have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.

In this scenario, which command configured on which nodes would solve this problem?

A.

the disable protocols evpn no-core-isolation command on the spine nodes

B.

the set protocols evpn no-core-isolation command on the spine nodes

C.

the disable protocols evpn no-core-isolation command on the leaf nodes

D.

the set protocols evpn no-core-isolation command on the leaf nodes

Full Access
Question # 18

You have successfully deployed an IP fabric in your data center. However, your server team complains that they are not seeing an increase in performance as expected. After examining the routing and forwarding tables, you notice that only a single route is listed to each destination in the forwarding table, even though there are multiple routes shown in the routing table.

In this scenario, what should you do to solve the problem?

A.

Write a load balancing policy and apply it to the routing table.

B.

Modify the hash algorithm so that only source and destination addresses are used.

C.

Write a load balancing policy and apply it to the forwarding table.

D.

Disable the Spanning Tree Protocol that is blocking the redundant paths.

Full Access
Question # 19

What is an advantage that EVPN has over VPLS when used for DCI?

A.

mass MAC withdrawal

B.

transparent BPDU transport

C.

active/standby multihoming

D.

reverse path forwarding

Full Access
Question # 20

The configuration shown in the exhibit is intended to set up assisted replication but will not

commit. Which action will create a valid configuration in this situation?

A.

Change the 10.0 address to 192.168.100.1 primary.

B.

Change the replicator inet address to 192.168.100.101.

C.

Delete replicator inet 192.168.100.1.

D.

Change the replicator inet address to 192.168.100. 51.

Full Access
Question # 21

You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF.In this scenario, how would you achieve this goal?

A.

Configure a VRF export policy on the BLUE VRF that matches the RED VRF route target.

B.

Configure the RED route target in the BLUE VRF.

C.

Configure the BLUE route target in the RED VRF.

D.

Configure a VRF import policy on the RED VRF that matches the BLUE VRF route target.

Full Access
Question # 22

What is the endpoint of a VXLAN tunnel?

A.

DLCI

B.

VTEP

C.

LSR

D.

VCF

Full Access
Question # 23

A VTEP requires which two interfaces? (Choose two.)

A.

a logical interface for a Layer 3 network

B.

a physical interface for a Layer 3 network

C.

a logical interface for a Layer 2 network

D.

a physical interface for a Layer 2 network

Full Access
Question # 24

You want to ensure high availability of the Junos devices in your data center. In this scenario, which three features would accomplish this task? (Choose three.)

A.

Multiple Spanning Tree Protocol

B.

Virtual Router Redundancy protocol

C.

graceful Routing Engine switchover

D.

Dual Routing Engineers

E.

Virtual private LAN service

Full Access
Go to page: