Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

N10-008 Exam Dumps - CompTIA Network+ Exam

Go to page:
Question # 153

A network administrator redesigned the positioning of the APs to create adjacent areas of wireless coverage. After project validation, some users still report poor connectivity when their devices maintain an association to a distanced AP. Which of the following should the network administrator check FIRST?

A.

Validate the roaming settings on the APs and WLAN clients

B.

Verify that the AP antenna type is correct for the new layout

C.

Check to see if MU-MIMO was properly activated on the APs

D.

Deactivate the 2.4GHz band on the APS

Full Access
Question # 154

A technician is installing a new fiber connection to a network device in a datacenter. The connection from the device to the switch also traverses a patch panel connection. The chain of connections is in the following order:

Device

LC/LC patch cable

Patch panel

Cross-connect fiber cable

Patch panel

LC/LC patch cable

Switch

The connection is not working. The technician has changed both patch cables with known working patch cables. The device had been tested and was working properly before being installed. Which of the following is the MOST likely cause of the issue?

A.

TX/RX is reversed

B.

An incorrect cable was used

C.

The device failed during installation

D.

Attenuation is occurring

Full Access
Question # 155

Which of the following BEST describes a network appliance that warns of unapproved devices that are accessing the network?

A.

Firewall

B.

AP

C.

Proxy server

D.

IDS

Full Access
Question # 156

Which of the following service models would MOST likely be used to replace on-premises servers with a cloud solution?

A.

PaaS

B.

IaaS

C.

SaaS

D.

Disaster recovery as a Service (DRaaS)

Full Access
Question # 157

A network device is configured to send critical events to a syslog server; however, the following alerts are not being received:

Severity 5 LINK-UPDOWN: Interface 1/1, changed state to down

Severity 5 LINK-UPDOWN: Interface 1/3, changed state to down

Which of the following describes the reason why the events are not being received?

A.

The network device is not configured to log that level to the syslog server

B.

The network device was down and could not send the event

C.

The syslog server is not compatible with the network device

D.

The syslog server did not have the correct MIB loaded to receive the message

Full Access
Question # 158

Wireless users are reporting intermittent internet connectivity. Connectivity is restored when the users disconnect and reconnect, utilizing the web authentication process each time. The network administrator can see the devices connected to the APs at all times. Which of the following steps will MOST likely determine the cause of the issue?

A.

Verify the session time-out configuration on the captive portal settings

B.

Check for encryption protocol mismatch on the client’s wireless settings

C.

Confirm that a valid passphrase is being used during the web authentication

D.

Investigate for a client’s disassociation caused by an evil twin AP

Full Access
Question # 159

A user reports being unable to access network resources after making some changes in the office. Which of the following should a network technician do FIRST?

A.

Check the system’s IP address

B.

Do a ping test against the servers

C.

Reseat the cables into the back of the PC

D.

Ask what changes were made

Full Access
Question # 160

An IT organization needs to optimize speeds for global content distribution and wants to reduce latency in high-density user locations. Which of the following technologies BEST meets the organization’s requirements?

A.

Load balancing

B.

Geofencing

C.

Public cloud

D.

Content delivery network

E.

Infrastructure as a service

Full Access
Go to page: