Note! Following 156-315.77 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

156-315.77 Exam Dumps - Check Point Certified Security Expert

Go to page:

<< First
Prev
3
4
5
6
7
8
9
10
11
12
Next
Last >>

Question # 81

SmartReporter reports can be used to analyze data from a penetration-testing regimen in all of the following examples, EXCEPT:

Analyzing traffic patterns against public resources.

Possible worm/malware activity.

Analyzing access attempts via social-engineering.

Tracking attempted port scans.

Full Access

Question # 82

The process that performs the authentication for Smart Dashboard is:

fwm

vpnd

cvpnd

cpd

Full Access

Question # 83

A Smart ProvisioningGateway could be a member of which VPN communities?

(i) Center In Star Topology

(ii) Satellite in Star Topology

(iii) Carter in Remote Access Community

(iv) Meshed Community

(ii) and (iii)

All

(i), (ii) and (iii)

(ii) only

Full Access

Question # 84

What type of packet does a VPN-1 SecureClient send to its Policy Server, to report its Secure Configuration Verification status?

ICMP Port Unreachable

TCP keep alive

IKE Key Exchange

ICMP Destination Unreachable

UDP keep alive

Full Access

Question # 85

Which Security Servers can perform Content Security tasks, but CANNOT perform authentication tasks?

Telnet

FTP

SMTP

HTTP

Full Access

Question # 86

Your customer asks you about the Performance Pack.

You explain to him that a Performance Pack is a software acceleration product which improves the performance of the Security Gateway.

You may enable or disable this acceleration by either:

1) the command:cpconfig

2) the command: fwaccel on ff

What is the difference between these two commands?

The fwaccel command determines the default setting. The command cpconfig can dynamically change the setting, but after the reboot it reverts to the default setting.

Both commands function identically.

The command cpconfig works on the Security Platform only. The command fwaccel can be used on all platforms.

The cpconfig command enables acceleration. The command fwaccel can dynamically change the setting, but after the reboot it reverts to the default setting.

Full Access

Question # 87

Which of the following operating systems support numbered VTI's?

Secure PlatformPro

Solaris

IPSO 4.0 +

Windows Server 2008

Full Access

Question # 88

You set up a mesh VPN Community, so your internal networks can access your partner's network, and vice versa. Your Security Policy encrypts only FTP and HTTP traffic through a VPN tunnel. All other traffic among your internal and partner networks is sent in clear text.

How do you configure the VPN Community?

Disable "accept all encrypted traffic", and put FTP and HTTP in the Excluded services in the Community object. Add a rule in the Security Policy for services FTP and http, with the Community object in the VPN field.

Disable "accept all encrypted traffic" in the Community, and add FTP and HTTP services to the Security Policy, with that Community object in the VPN field.

Enable "accept all encrypted traffic", but put FTP and HTTP in the Excluded services in the Community. Add a rule in the Security Policy, with services FTP and http, and the Community object in the VPN field.

Put FTP and HTTP in the Excluded services in the Community object. Then add a rule in the Security Policy to allow Any as the service, with the Community object in the VPN field.

Full Access

Go to page: