201-450 Exam Dumps - LPIC-2 Exam 201, Part 1 of 2, version 4.5

Go to page:

Question # 9

According to the tcpdump output below, what is the IP address of the client host?

02:12:40.511381 IP 192.168.246.11.1045 > 192.168.246.1.22: S 3838532429:3838532429(0) win 5840

02:12:40.511540 IP 192.168.246.1.22 > 192.168.246.11.1045: S 1209330085:1209330085(0) ack 383853 2430 win 5792

02:12:40.511755 IP 192.168.246.11.1045 > 192.168.246.1.22: . ack 1 win 1460

02:12:40.515122 IP 192.168.246.1.22 > 192.168.246.11.1045: P 1:26(25) ack 1 win 5792

02:12:40.515511 IP 192.168.246.11.1045 > 192.168.246.1.22: . ack 26 win 1460

02:12:40.515952 IP 192.168.246.11.1045 > 192.168.246.1.22: P 1:23(22) ack 26 win 1460

Full Access

Question # 10

Under which of the following circumstances would the command ping output the string (DUP!)?

When the ICMP packets are send to a broadcast address and multiple hosts respond.

When the host being sent ICMP packets is on a different network.

When the router responds to the ICMP packet in addition to the host receiving the ICMP packets.

When the host sending the ICMP packet is the same host as the one receiving the ICMP packets.

Full Access

Question # 11

Which commands are used to load modules into the Linux kernel? (Choose TWO correct answers.)

insmod

loadmod

kernload

modprobe

probemod

Full Access

Question # 12

What is a key difference between a zImage and bzImage kernel image?

zImage is compressed using gzip, bzImage is compressed using bzip2.

zImage is for 2.6 series kernels, bzImage is for 3.x series kernels.

zImage is limited to 64k, bzImage has no such restriction.

zImage gets loaded completely into low memory. bzImage will load into high memory once low memory is full.

Full Access

Question # 13

If all of the following files and/or symlinks exist in a SysV-init runlevel directory, which of the following will be executed first when booting the system directly into the runlevel?

S99lpi

K99lpi

PRE-S99lpi

S98lpi

S99a-lpi

Full Access

Question # 14

Where is the LILO boot loader code typically installed on a system with only a single Linux installation and no other operating systems?

In the master boot record.

In the boot sector.

In the /boot directory.

At the start of the kernel.

Full Access

Question # 15

What should be done to ensure a client machine uses the recursive nameserver running on the IP address 192.168.0.1? (Choose TWO correct answers.)

Add nameserver 192.168.0.1 to /etc/resolv.conf.

Run route add nameserver 192.168.0.1.

Run ifconfig eth0 nameserver 192.168.0.1.

Ensure that the dns service is listed in the hosts entry in the /etc/nsswitch.conf file.

Run bind add nameserver 192.168.0.1.

Full Access

Question # 16

A server requires a GRUB2 boot option which will always boot to runlevel 1. Which line of a GRUB2 configuration file starts the beginning of the settings needed to make this new choice available?

initrd

linux

menuentry

runlevel

Full Access

Go to page: