Special Summer Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

300-515 Exam Dumps - Implementing Cisco Service Provider VPN Services (300-515 SPVI)

Go to page:
Question # 4

Refer to the exhibit.

The CE router has established a BGP peering with the PE router, and the CE will use the core infrastructure of the PE as a backbone carrier to support CSC. Which additional task can you perform to complete the configuration?

A.

Configure static routing on the CE router.

B.

Configure the address-family ipv4 labeled-unicast command under the neighbor configuration of the CE router for the PE.

C.

Change the rd value to 65001:65001 under the VRF section of the PE router.

D.

Configure OSPF on the PE router.

Full Access
Question # 5

In a typical service provider environment, which two tools are used to help scale PE router connectivity requirements? (Choose two.)

A.

route reflectors

B.

VPNv4 address family

C.

originator ID

D.

cluster ID

E.

confederations

Full Access
Question # 6

Refer to the exhibit.

An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?

A.

headend

B.

source

C.

transit

D.

bud

Full Access
Question # 7

Which two frames can be configured on an Ethernet flow point? (Choose two.)

A.

of a specific VLAN

B.

with different type of service values

C.

with identical type of service value

D.

with different class of service values

E.

with no tags

Full Access
Question # 8

Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

A.

In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

B.

OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0

C.

OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

D.

IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

Full Access
Go to page: