300-615 Exam Dumps - Troubleshooting Cisco Data Center Infrastructure (300-615 DCIT)

Go to page:

Question # 17

Refer to the exhibit The EEM applet must generate a syslog message whena BGP adjacency faps. This message must be displayed to the console of the switch. However, when a BGP adjacency failure is simulated, no syslog message is displayed. Which action resolves the issue?

Add the event-default action statement.

Modify the policy to use the snmp trap action.

Adjust the policy to match an SNMP OID.

Set the logging priority to Wamings.

Full Access

Question # 18

Refer to the exhibit.

When an engineer inserts 8-Gb FC SFP port 15 on a Cisco UCS Fabric Interconnect, the port fails. What is a possible cause of the issue?

Port 15 is configured as an Ethernet port.

Port 15 is configured for 4-Gb FC.

Port 15 is missing a license.

The polarity of the fiber cable is reversed.

Full Access

Question # 19

A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?

Use route-map to advertise this MAC statically and redistribute with ISIS.

Unknown unicast flooding is not allowed.

Use the otv flood mac <> command to selectively flood traffic for a given MAC.

Use the otv isis bfd <> command to configure BFD protocol.

Full Access

Question # 20

Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.

Full Access

Question # 21

Refer to the exhibit.

An engineer fails to install Perl in the guest shell on a Cisco Nexus 9000 Series Switch. Which two actions must be taken in the guest shell to resolve the issue? (Choose two.)

Add the DNS server and suffix.

Add a default gateway and nameserver.

Install the unbound resolver package using curl.

Configure domain-name and nameserver under the management VRF.

Export the http_proxy and https_proxy environment variables

Full Access

Question # 22

An engineer experiences an issue presented with the Cisco ucs system. Which action resolves the issue?

Change the discovery policy backplane speed preference to 4x10G.

Connect the adapter to the fabric interconnects using a breakout cable.

Update the 1/O module firmware on the Cisco UCS chassis.

Reboot the blade server and acknowledge the fault.

Full Access

Question # 23

Refer to the exhibit.

A Cisco UCS Fabric Interconnect fails during the upgrade process. The working images of the fabric interconnect are stored on the bootflash. Which set of commands recovers the fabric interconnect?

loader> dir

loader> boot ucs-6300-k9-kickstart.5.0.2.N1.3.02d56.bin

switch(boot)# init system

switch(boot)# reload

switch(boot)# load ucs-6300-k9-system.5.0.2.N1.3.02d56.bin

loader> dir

loader> boot ucs-6300-k9-kickstart.5.0.2.N1.3.02d56.bin

switch(boot)# copy ics-manager-k9.1.4.1k.bin nuova-sim-mgmt-nsg.0.1.001.bin

switch(boot)# boot ucs-6300-k9-system.5.0.2.N1.3.02d56.bin

loader> dir

loader> boot ucs-6300-k9-kickstart.5.0.2.N1.3.02d56.bin

switch(boot)# init system