Weekend Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

300-710 Exam Dumps - Securing Networks with Cisco Firepower (300-710 SNCF)

Go to page:
Question # 9

Within an organization's high availability environment where both firewalls are passing traffic, traffic must be segmented based on which department it is destined for. Each department is situated on a different LAN. What must be configured to meet these requirements?

A.

span EtherChannel clustering

B.

redundant interfaces

C.

high availability active/standby firewalls

D.

multi-instance firewalls

Full Access
Question # 10

What are the minimum requirements to deploy a managed device inline?

A.

inline interfaces, security zones, MTU, and mode

B.

passive interface, MTU, and mode

C.

inline interfaces, MTU, and mode

D.

passive interface, security zone, MTU, and mode

Full Access
Question # 11

Which connector is used to integrate Cisco ISE with Cisco FMC for Rapid Threat Containment?

A.

pxGrid

B.

FTD RTC

C.

FMC RTC

D.

ISEGrid

Full Access
Question # 12

What is the maximum SHA level of filtering that Threat Intelligence Director supports?

A.

SHA-1024

B.

SHA-4096

C.

SHA-512

D.

SHA-256

Full Access
Question # 13

An organization has a Cisco FTD that uses bridge groups to pass traffic from the inside interfaces to the outside interfaces. They are unable to gather information about neighbouring Cisco devices or use multicast in their environment. What must be done to resolve this issue?

A.

Create a firewall rule to allow CDP traffic.

B.

Create a bridge group with the firewall interfaces.

C.

Change the firewall mode to transparent.

D.

Change the firewall mode to routed.

Full Access
Question # 14

Which two conditions are necessary for high availability to function between two Cisco FTD devices? (Choose two.)

A.

The units must be the same version

B.

Both devices can be part of a different group that must be in the same domain when configured within the FMC.

C.

The units must be different models if they are part of the same series.

D.

The units must be configured only for firewall routed mode.

E.

The units must be the same model.

Full Access
Question # 15

Which two routing options are valid with Cisco FTD? (Choose Two)

A.

BGPv6

B.

ECMP with up to three equal cost paths across multiple interfaces

C.

ECMP with up to three equal cost paths across a single interface

D.

BGPv4 in transparent firewall mode

E.

BGPv4 with nonstop forwarding

Full Access
Question # 16

A network engineer is receiving reports of users randomly getting disconnected from their corporate applications which traverses the data center FTD appliance Network monitoring tools show that the FTD appliance utilization is peaking above 90% of total capacity. What must be done in order to further analyze this issue?

A.

Use the Packet Export feature to save data onto external drives

B.

Use the Packet Capture feature to collect real-time network traffic

C.

Use the Packet Tracer feature for traffic policy analysis

D.

Use the Packet Analysis feature for capturing network data

Full Access
Go to page: