4A0-104 Exam Dumps - Alcatel-Lucent Services Architecture

An IES has a configurable VC MTU.

An IES interface has an IP address assigned to it.

IES supports QoS.

An IES requires a spoke SDP.

The frame egresses 1/1/1:6.7 with an outer VLAN tag of 6 and inner tag of 7.

The frame is dropped at the egress SAP 1/1/1:6.7.

The frame egresses 1/1/1:6.7 with VLAN tag 5.

The frame egresses 1/1/1:6.7 with VLAN tag 6.

It will show the hops taken between service endpoints.

It will test the delay across the service.

It will test the SDPs of a service in both directions.

It will test the round-trip connectivity of the service.

An IES requires a spoke SDP.

A virtual route table must be configured for an IES service.

An IES service must use static routes to communicate with customer networks.

An IES must have at least one SAP defined.

Route targets are carried in MP-BGP updates.

Route targets identify the VRF that a VPN-IFV4 prefix is associated with.

Route targets are communicated between PEs that are part of a specific VPRN.

Route targets identify the egress SAP of a service towards a CE.

Yes. A routing policy is required to advertise routes between PE routers in a VPRN

No. A routing policy is not required; the default behavior on the 7750 SR is to advertise all VPRN routes between PE routers.

A routing policy is required only when BGP is used as the PE-CE routing protocol, as shown in the exhibit.

A CE1 system interface can not be advertised to PE2 since the CE routers are not aware of the VPRN.

The FCS is verified and the customer frame is transported intact over the service provider network.

The FCS is verified and kept in the customer frame. The VLAN tag is removed for transport over the network.

The FCS is verified and removed from the frame. The VLAN tag is kept for transport over the network.

The FCS is verified and removed from the frame. The VLAN tag is removed for transport over the network.

A "remote-source" needs to be added to the mirror destination on PEL

A mirror source needs to be added to PE1 with a "remote-source".

This is not possible since the protocol analyzer is located at the Central Office.It needs to be at the customer site.

A mirror source with SAP 1/1/2 needs to be added on PEL