Note! Following 4A0-111 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

4A0-111 Exam Dumps - Nokia Network and Service Router Security

Go to page:

Question # 9

What is true when using the apply button in Voyager (Choose one)

You are saving all changed settings on the device after a reboot.

Applying will make changes to /etc

You are applying to the active configuration which will not be saved after you reboot

You are resetting the devices startup configuration to the initial configuration

Full Access

Question # 10

Which of the following statements about the BGP Advertise External feature is FALSE?

It modifies the BGP advertisement logic.

It improves convergence times and allows for better load sharing.

It allows a router to advertise multiple external paths for a single prefix.

It supports both IPv4 and IPv6.

Full Access

Question # 11

Based on the following CLI Output, why is the path toPod3-loose down?

Path toPod3-loose is down because it is secondary path with no standby configured

Path toPod3-loose is down because there is no explicit hop specified

Path toPod3-loose is down because CSPF is not enabled

Path toPod3-loose is down because the destination address 0.10.1.3 is not reachable

Path toPod3-loose is not down because the failure code is oError

Full Access

Question # 12

What command in boot manager sets the Kernel path to boot from (Choose one)

Newpkg -p

set boot

boot-file

bootp

Full Access

Question # 13

Where does Nokia with Checkpoint FW-1 work on the OSI model (Choose one)

Between layers 2 and 3

Between layers 3 and 4

Between layers 4 and 5

Full Access

Question # 14

What is the correct command for using Tcpdump to monitor NTP traffic on Eth

Port 3 Slot 1 (Choose one)

tcpdump -k s1p1c1 ntp

tcpdump -i eth-s1-p3 port 123

tcpdump -v s1p3c1 ntp -all

tcpdump -i -e eth-s1-p1 ntp

Full Access

Question # 15

LSP toNode3 is configured on Node1, all hops configured in the lsp path and lsp destination address are reachable via IGP. Both primary and secondary LSP paths are down with failure code equal toRoute ToDestionation. What is the potential cause of this problem?