640-692 Exam Dumps - CCT Routing & Switching

Go to page:

Question # 4

While performing password recovery on a Cisco device, the configuration register should be which value in order to bypass loading the startup configuration?

0x2102

0x2112

0x2122

0x2142

Full Access

Question # 5

Which bits represent the boot field in the configuration register value?

highest two bits

highest four bits

lowest two bits

lowest four bits

Full Access

Question # 6

Full Access

Question # 7

Which type if memory is used to permanently store the Cisco IOS software?

Flash

DRAM

SRAM

NVRAM

Full Access

Question # 8

Which of the following best describes how to assign a static IP address to the Ethernet port on a computer?

From network Connections, click Create a New Connection and follow the network connection Wizard instructions.

From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information.

Click Start> Run Enter cmd and click OK. Enter ip address XXX.XXX.XXX.XXX.

From Network Connections, double-click Local Connection. Click Properties, click iPass Protocol (IEEE), click properties and select static IP.

Full Access

Go to page: