Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

ACE-A1.2 Exam Dumps - Arista Certified Engineering Associate Exam

Go to page:
Question # 4

What will the following command do?

show event-monitor arp | grep 10.100.100.6

A.

Show all the historical ARP entry changes on the remote Arista switch located at IP address 10.100.100.6

B.

Show all the event-monitors for a switch that has an ARP address matched to the IP address 10.100.100.6

C.

Show all historical ARP entry changes that contain the IP address 10.100.100.6

D.

This is not a valid command

Full Access
Question # 5

On an Arista switch, what two commands can you use to write your changes from the running-configuration to the startup-configuration?

A.

write

B.

copy running-config startup-config

C.

save

D.

save memory

Full Access
Question # 6

Which of the following are valid commands on EOS 4.14? (Choose three.)

A.

show run all

B.

show run diffs

C.

show run sanitized

D.

show run section

Full Access
Question # 7

With two switches in an MLAG domain, which of the following commands is a legitimate way to make interfaces on one of the peers part of mlag 43?

A.

Peer-1(config-if-Po43) #mlag 43

B.

Peer-1(config-if-Et43) #mlag 43

C.

Peer-1(config-if-Vl43) #mlag 43

D.

There can only be 32 MLAGs on a switch, so MLAG 43 is impossible.

Full Access
Question # 8

On EOS 4.15 and above, the ability to show JSON output for EOS CLI commands is available. Which of the following will successfully produce JSON output for the show version command?

A.

show version | show json

B.

show version | json

C.

show json | show version

D.

show version json

Full Access
Go to page: