Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

Note! Following CWAP-403 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is CWAP-404

CWAP-403 Exam Dumps - Certified Wireless Analysis Professional

Go to page:
Question # 4

A PHY Header is added to the PSDU at which sub-layer?

A.

LLC

B.

MAC

C.

PLCP

D.

PMD

Full Access
Question # 5

As a wireless network consultant you have been called in to troubleshoot a high-priority issue for one of your customers. The customer’s office is based on two floors within a multi-tenant office block. On one of these floors (floor 5) users cannot connect to the wireless network. During their own testing the customer has discovered that users can connect on floor 6 but not when they move to the floor 5. This issue is affecting all users on floor 5 and having a negative effect on productivity.

To troubleshoot this issue, you perform both Spectrum and Protocol Analysis. The Spectrum Analysis shows the presence of Bluetooth signals which you have identified as coming from wireless mice. In the protocol analyzer you see the top frame on the network is Deauthentication frames. On closer investigation you see that the Deauthentication frames’ source addresses match the BSSISs of your customers APs and the destination address is FF:FF:FF:FF:FF:FF:FF.

What do you conclude from this troubleshooting exercise?

A.

The customer should replace all their Bluetooth wireless mice as they are stopping the users on floor 5

from connecting to the wireless network

B.

The users on floor 5 are being subjected to a denial of service attack, as this is happening across the

entire floor it is likely to be a misconfigured WIPS solution belonging to the tenants on the floor below

C.

The customers APs are misbehaving and a technical support case should be open with the vendor

D.

The CCI from the APs on the floor 4 is the problem and you need to ask the tenant below to turn down their AP’s Tx power

Full Access
Question # 6

Where would you look in a packet trace file to identify the configured Minimum Basic Rate (MBR) of a BSS?

A.

Supported Rates & Extended Supported Rates elements in a Beacon frame

B.

In the MBR Action frame

C.

In the Minimum Basic Rate Element in a Beacon frame

D.

In the MBR Information Element in an Association Response frame

Full Access
Question # 7

When would you expect to see a Reassociation Request frame?

A.

Every time a STA associates to an AP to which it has previously been associated

B.

Only when a STA is using FT roaming

C.

Only when a STA roams back to an AP it has previously been associated with

D.

Every time a STA roams

Full Access
Question # 8

802.11k Neighbor Requests and Neighbor Reports are sent in what type of Management Frames?

A.

RRM

B.

Action

C.

Beacon

D.

Reassociation Request and Reassociation Response

Full Access
Go to page: