DES-1721 Exam Dumps - Specialist - Implementation Engineer SC Series Exam

Go to page:

Question # 17

A file server using an SC7020 storage array was impacted by ransomware in the morning and a majority of the files need to be recovered. The backup from the previous night did not run. Is there anything that can be done on the SC7020 array to help recover these files?

Yes, if there is a snapshot from before the ransomware on the volume(s) were impacted. Volume(s) can be rolled back to this snapshot.

Nothing can be done on the SC7020 to assist with this recovery.

Yes, if there is a snapshot from before the ransomware on the volume(s) were impacted. A Replay can be created from this snapshot and the files recovered.

Yes, if there is a snapshot from before the ransomware on the volume(s) were impacted. A View volume can be created from this snapshot and the files recovered.

Full Access

Question # 18

You are on-site to install 2 new Brocade switches with a Storage Center. By default, every new Brocade switch IP address is set to 10.77.77.77. What is the command to check the IP address of a Brocade switch?

cfgShow

configipaddr

ipaddrshow

showconfig

Full Access

Question # 19

Which configuration represents how the back-end is cabled on an SC7020 storage array without expansion enclosures?

Configuration A

Configuration B

Configuration C

Configuration D

Full Access

Question # 20

You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches. What is the minimum number of port(s), per switch, that can be used by each controller?

One port on each Ethernet switch

Two ports on each Ethernet switch

Four ports on each Ethernet switch

Eight ports on each Ethernet switch

Full Access

Question # 21

When an RS-232 serial cable is connected between a service laptop and SC Series hardware, which parameters need to be selected?

Baud Rate = 9600, Parity = NoneData Bits = 8, Stop Bits =1, Flow Control = XON/XOFF

Baud Rate = 115200, Parity = NoneData Bits = 8, Stop Bits = 1, Flow Control = XON/XOFF

Baud Rate = 115200, Parity =NoneData Bits = 8, Stop Bits = 1, Flow Control = None

Baud Rate = 115200, Parity = EvenData Bits = 8, Stop Bits = 1, Flow Control = XON/XOFF

Full Access