Halloween Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

DES-5221 Exam Dumps - Specialist Implementation Engineer Data Center Networking Exam

Searching for workable clues to ace the EMC DES-5221 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s DES-5221 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:
Question # 4

Refer to the exhibit.

A default route exists on OS10-C that points all internet traffic towards 10.0.13.3 on OS10-B. A network administrator needs to re-route internet traffic only sourced from Host-1 to 10.0.12.2 on OS10-A instead. What feature can the administrator implement to accomplish this goal?

A.

Static Default Routing

B.

OSPF Cost Manipulation

C.

Source-Based Routing

D.

Policy-Based Routing

Full Access
Question # 5

When configuring a vrf instance for the management interface that has been in use, what step must be done first to configure it?

A.

Configure a management route

B.

Remove the default route

C.

Remove all configured settings

D.

Configure an IP Address

Full Access
Question # 6

A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?

A.

Spanning tree Loop-guard was implemented on the uplink-state group.

B.

One of the upstream interfaces is an uplink-state group went down.

C.

There was no issue; this is normal behavior.

D.

Both a port channel and its members were assigned to an uplink-state group.

Full Access
Question # 7

When installing OS10 on a switch from a USB drive, what format is used for the file system?

A.

HFS+

B.

FAT32

C.

NTFS

D.

HFS

Full Access
Question # 8

A customer has disabled LLDP on the management interface of the switch. What is the proper command to re- enable it?

A.

OS10(config)# lldp enable OS10(config)#lldp transmit OS10(config)#lldp receive

B.

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp med enable OS10(conf-if-ma-1/1/1)#lldp timer 10

C.

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp transmit OS10(conf-if-ma-1/1/1)#lldp receive

D.

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp tly-select OS10(conf-if-ma-1/1/1)#lldp dot1tlv

Full Access
Go to page: