New Year Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

H12-811_V1.0 Exam Dumps - HCIA-Datacom V1.0 Exam

Go to page:
Question # 217

The configuration information of a certain port of the switch is shown in the figure. What is the PVID of this port? () (Single-choice question)

A.

100

B.

2

C.

4

D.

1

Full Access
Question # 218

Complete the ACL configuration shown in the figure on the router RTA. Which of the following descriptions is correct? () (Single-choice question)

(RTA) acl 2001

(RTA-acl-basic-2001) rule 20 permit source 20.1.1.0 0.0.0.255

ï¼»RTA-acl-basic-2001ï¼½rule 10 deny source 20.1.1.0 0.0.0.255

A.

The VRP system will adjust the sequence number of the first rule to 5 according to the configuration sequence.

B.

The VRP system will not adjust the sequence number, but will first match the rule permit source 20.1.1.00.0.0.255

C.

The VRP system will first match the rule deny source20.1.1.00.0.0.255 according to the sequence number.

D.

The sequence number of configuration error rules must be configured from small to large

Full Access
Question # 219

The network shown in the figure below. Which router is the BDR in this network? () (Single-choice question)

A.

B. Router B

B.

No BDR

C.

D. Router C

Full Access
Question # 220

As shown in the figure below, all hosts can communicate normally. Is the correspondence between the MAC address and the port in the MAC address table of SWB correct? () (Single-choice question)

A.

MAC-A GO/0/1

MAC-B GO/0/2

MAC-C GO/0/3

B.

MAC-A GO/0/2

MAC-B G0/0/2

MAC-C GO/0/3

C.

MAC-A GO/0/3

MAC-B GO/0/3

MAC-C GO/0/1

D.

MAC-A GO/0/1

MAC-B GO/0/1

MAC-C GO/0/3

Full Access
Question # 221

Which of the following is not included in AAA? ()

A.

Audit

B.

B. Authentication

C.

C. Authorization

D.

D. Accounting)

Full Access
Question # 222

As shown in the figure, the network administrator creates VLAN2 on SWA and SWB. The ports connecting the hosts on the two switches are configured as Access ports. They are assigned to VLAN2. G0/0/1 of SWA and G0/0/2 of SWB are configured as Trunki ports. All VLANs are allowed to pass. What is needed to achieve normal communication between two hosts? () (Single-choice question)

A.

Configure G0/0/1 on SWC as a trunk port and allow VLAN2 to pass. Set G0/0/2 as an access port. PVID is 2.

B.

Create VLAN2 on SWC, configure G0/0/1 and G0/0/2 as trunk ports, and allow VLAN2 to pass

C.

C. Just create BLAN2 on SWC

D.

Configure G0/0/1 on SWC as a teunk port and allow VLAN2 to pass through

Full Access
Question # 223

The following rules exist in an ACL of a router. Rule deny top source192.168, 1.00.0.0.255 destination 172.16.10.1 0.0.0.0 destination-port eq 21 is the correct statement? ()

A.

sourceIP is 192.168.1.1, destination P is 172.16.10.1, and all TCP packets with destination port number 21 match this rule

B.

The source IP is 192.168.1.1, the destination IP is 172.16.10.2, and all 1CP packets whose destination port number is 21 match this rule

C.

Rule sourceIP is 192.168.1.1, the destination IP is 72.16.10.3, and all TCP packets with the destination port number of 21 match this rule

D.

D. The type of ACL is basic ACL

Full Access
Question # 224

The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? ()

interface GigabitEthernet0/0/1 port link type trunk port trunk pviD.vlan 200 port trunk allow-pass vlan100#

A.

If the VLAN TAG carried in the data frame is 100, the switch will strip off the VLAN TAG and send it out

B.

This port cannot send data frames carrying VLAN TAG200

C.

C. The port type is Trunk type

D.

If the port receives a data frame without VLAN TAG, the switch needs to add VLAN TAG 200

Full Access
Go to page: