New Year Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

H12-831_V1.0 Exam Dumps - HCIP-Datacom-Advanced Routing & Switching Technology V1.0

Go to page:
Question # 65

On the OSPFv3 network shown in the figure, OSPFv3 is enabled on the interfaces connecting R1, R2, and R3. The router ID of each router is 10.0.X.X, where X is the number of the router. If you check detailed information about an LSA on R3, the command output shows that the LSA is generated by R2 and describes the IPv6 prefix address associated with the Router-LSA.

A.

TRUE

B.

FALSE

Full Access
Question # 66

An interface of a switch is in error-down state. A possible cause is that the average rate of broadcast packets received by the interface exceeds the upper threshold set by the administrator for storm control.

A.

TRUE

B.

FALSE

Full Access
Question # 67

BGP/MPLS IP VPNs can only use LDP to construct public network tunnels.

A.

True

B.

False

Full Access
Question # 68

Please match 0SPFv3LSA with its transmission range.

Full Access
Question # 69

What types of Link Types are included in the Router LSA in OSPF?

A.

Vlink

B.

Stub Net

C.

TransNet

D.

P-2-P

Full Access
Question # 70

What check items can be set by IPSG?

A.

MA, Caddress

B.

Outgoing interface

C.

VLANID

D.

IPaddress

Full Access
Question # 71

As shown below:

A.

in the pictureLSAis generated by this router

B.

ShouldLSAThe described destination network is10.0.23.0/24

C.

ShouldLSAis of typeAS-extermal-LSA

D.

This device isA, BR

Full Access
Question # 72

To support the processing and calculation of IPv6 routes, IS-IS adds a new NLPID to TLV 129. The NLPID is an 8-bit field that identifies network layer protocol packets. Which of the following is the NLPID of IPv6?

A.

232

B.

142

C.

204

D.

236

Full Access
Go to page: