NSE6_FWF-6.4 Exam Dumps - Fortinet NSE 6 - Secure Wireless LAN 6.4

Go to page:

Question # 4

Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

DARRP measurements can be scheduled to occur at specific times.

DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

Full Access

Question # 5

A tunnel mode wireless network is configured on a FortiGate wireless controller.

Which task must be completed before the wireless network can be used?

The wireless network interface must be assigned a Layer 3 address

Security Fabric and HTTPS must be enabled on the wireless network interface

The wireless network to Internet firewall policy must be configured

The new network must be manually assigned to a FortiAP profile.

Full Access

Question # 6

You are investigating a wireless performance issue and you are trying to audit the neighboring APs in the PF environment. You review the Rogue APs widget on the GUI but it is empty, despite the known presence of other APs.

Which configuration change will allow neighboring APs to be successfully detected?

Enable Locate WiFi clients when not connected in the relevant AP profiles.

Enable Monitor channel utilization on the relevant AP profiles.

Ensure that all allowed channels are enabled for the AP radios.

Enable Radio resource provisioning on the relevant AP profiles.

Full Access