Note! Following NSE7_OTS-6.4 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is NSE7_OTS-7.2

NSE7_OTS-6.4 Exam Dumps - Fortinet NSE 7 - OT Security 6.4

Go to page:

Question # 4

Which three Fortinet products can be used for device identification in an OT industrial control system (ICS)? (Choose three.)

FortiNAC

FortiManager

FortiAnalyzer

FortiSIEM

FortiGate

Full Access

Question # 5

As an OT administrator, it is important to understand how industrial protocols work in an OT network.

Which communication method is used by the Modbus protocol?

It uses OSI Layer 2 and the primary device sends data based on request from secondary device.

It uses OSI Layer 2 and both the primary/secondary devices always send data during the communication.

It uses OSI Layer 2 and both the primary/secondary devices send data based on a matching token ring.

It uses OSI Layer 2 and the secondary device sends data based on request from primary device.

Full Access

Question # 6

Refer to the exhibit

In the topology shown in the exhibit, both PLCs can communicate directly with each other, without going through the firewall.

Which statement about the topology is true?

PLCs use IEEE802.1Q protocol to communicate each other.

An administrator can create firewall policies in the switch to secure between PLCs.

This integration solution expands VLAN capabilities from Layer 2 to Layer 3.

There is no micro-segmentation in this topology.

Full Access

Question # 7

An OT network architect needs to secure control area zones with a single network access policy to provision devices to any number of different networks.

On which device can this be accomplished?

FortiGate

FortiEDR

FortiSwitch

FortiNAC

Full Access

Question # 8

Refer to the exhibit.