Note! Following NSE7_SDW-6.4 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is NSE7_SDW-7.2

NSE7_SDW-6.4 Exam Dumps - Fortinet NSE 7 - SD-WAN 6.4.5

Go to page:

Question # 9

Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.

Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

Full Access

Question # 10

What is the purpose of a predefined template on the FortiAnalyzer?

It can be edited and modified as required

It specifies the report layout which contains predefined texts, charts, and macros

It specifies report settings which contains time period, device selection, and schedule

It contains predefined data to generate mock reports

Full Access

Question # 11

Refer to the exhibits.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member and the static routes configuration.

If port2 is detected dead by FortiGate, which expected behavior is correct?

Port2 becomes alive after one successful probe is detected.

The SD-WAN interface becomes disabled and port1 becomes the WAN interface.

Dead members require manual administrator access to bring them back alive.

Subnets 10.0.20.0/23 and 172.20.0.0/16 are reachable only through port1.

Full Access

Question # 12

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

Specify incoming interfaces in SD-WAN rules.

Full Access

Go to page: