Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

Note! Following NSE7_SDW-7.0 Exam is Retired now. Please select the alternative replacement for your Exam Certification. The new exam code is NSE7_SDW-7.2

NSE7_SDW-7.0 Exam Dumps - Fortinet NSE 7 - SD-WAN 7.0

Go to page:
Question # 9

Refer to the exhibits.

Exhibit A

Exhibit B

Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.

Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)

A.

The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.

B.

FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.

C.

FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.

D.

Non-TCP Facebook and YouTube traffic are not used for performance measurement.

Full Access
Question # 10

Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

A.

Interface-based shaping mode

B.

Reverse-policy shaping mode

C.

Shared-policy shaping mode

D.

Per-IP shaping mode

Full Access
Question # 11

Refer to the exhibit.

The device exchanges routes using IBGP.

Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

A.

Each BGP route is three hops away from the destination.

B.

ibgp-multipath is disabled.

C.

additional-path is enabled.

D.

You can run the get router info routing-table database command to display the additional paths.

Full Access
Question # 12

Refer to the exhibits.

Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)

A.

FortiGate does not install IPsec static routes for remote protected networks in the routing table.

B.

The phase 1 configuration supports the network-overlay setting.

C.

FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.

D.

Dead peer detection is disabled.

Full Access
Question # 13

Refer to the exhibit.

The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)

A.

The reply direction of the asymmetric traffic flows from port2 to port3.

B.

The auxiliary session can be offloaded to hardware.

C.

The original direction of the symmetric traffic flows from port3 to port2.

D.

The main session cannot be offloaded to hardware.

Full Access
Question # 14

Exhibit.

Which conclusion about the packet debug flow output is correct?

A.

The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

B.

The packet size exceeded the outgoing interface MTU.

C.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

D.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.

Full Access
Question # 15

Which statement is correct about SD-WAN and ADVPN?

A.

Routes for ADVPN shortcuts must be manually configured.

B.

SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.

C.

SD-WAN does not monitor the health and performance of ADVPN shortcuts.

D.

You must use IKEv2 on IPsec tunnels.

Full Access
Question # 16

Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

A.

The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

B.

The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

C.

The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.

D.

The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

Full Access
Go to page: