300-510 Exam Dumps - Implementing Cisco Service Provider Advanced Routing Solutions

Refer to the exhibit.

Traffic flow from router R1 to router R6 is delay-sensitive It must consider potential link-failure and node-failure conditions Which configuration must an engineer apply to router R1 to route traffic to router R6 if router R2 fails?

Refer to the exhibit. Which duplicate configuration causes this message during setup of an MPLS BGP network?

For which reason can two BGP peers fail to establish a neighbor relationship?

Refer to the exhibit

Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is

enabled?

Refer to the exhibit While troubleshooting a networking issue an engineer identified a suboptimal communication issue on route reflector RR2 In the current environment

• Router A is a non-route-reflector client for RR1 and RR2
• Routers D and E are directly connected iBGP peers.
• Router F is not an iBGP peer of routers D and E

Which action resolves the issue?

Refer to the exhibit Router 1 resides in a different data center than Rouler 2 and Router 3. Router 1 is running the IS-IS routing protocol, and it is preconfigured with LDP and segment routing Which configuration must the engineer apply under router isis 111 on Router 1 to implement Tl-LFA on the link to Router 2 without disrupting traffic to Router 3?

A)

B)

C)

D)

Refer to the exhibit. Users connected to an application on 1.1.1.1 via routers CE1 and CE2 are complaining of frequent disconnections. While troubleshooting the issue, a network engineer with an employee ID: 4333:96:916 determined that the application itself is working normally, but the link connected to the 1.1.1.1 application is flapping. The users on CE1 and CE2 are accessing applications on 2.2.2.2 without difficulty. Which action resolves the issue?

For which reason can two devices fail to establish an OSPF neighbor relationship?