300-510 Exam Dumps - Implementing Cisco Service Provider Advanced Routing Solutions

Guidelines

This is a lab item in which tasks will be performed on virtual devices.

Refer to the Tasks tab to view the tasks for this lab item.

Refer to the Topology tab to access the device console(s) and perform the tasks.

Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.

All necessary preconfigurations have been applied.

Do not change the enable password or hostname for any device.

Save your configurations to NVRAM before moving to the next item.

Click Next at the bottom of the screen to submit this lab and move to the next question.

When Next is clicked, the lab doses and cannot be reopened.

Topology

Tasks

Configure and verify an OSPF neighbor adjacency between R1 and R2 in OSPF area 0 according to the topology to achieve these goals:

1. R1 pings the Loopback0 interface of R2. Use interface-level configuration to complete this task.

2. R2 pings the Loopback0 interface of R1. Use interface-level configuration to complete this task.

3. R2 receives a single summary route 172.16.100.0/22 for networks 172.16.100.0/24, 172.16.101.0/24, and 172.16.103.0/24.

Refer to the exhibit.

Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3. Which action corrects the problem?

Refer to the exhibit. R21 is a multicast source sending multicast traffic 224.1.1.1 to R23, with RP22 serving as the rendezvous point inside AS65222. A network engineer noticed that when R21 goes down, R12 in AS65111 starts to send the same multicast group 224.1.1.1 through RP11. Which action resolves the issue ?

Refer to the exhibit.

Router 1 is connected to router 2 on interface TenGigE0/1. Which interface provides the

alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?

Refer to the exhibit.

An engineer is troubleshooting connectivity issues on the MPLS core network. A customer connected through R4 cannot reach the OSPF domain on R5. While checking the routing table of R1, the engineer cannot see all the routes from R3 and R5. Which task must the engineer perform so that R4 is able to reach R5?

Which IPv6 prefix format defines the destination of a dynamic 6to4 tunnel?

Drag and drop the route-manipulation methods from the left onto their features on the right

Drag and drop the features from the left onto the corresponding routing protocols on the right