300-815 Exam Dumps - Implementing Cisco Advanced Call Control and Mobility Services (CLACCM)
An administrator is configuring Meet-me conferencing in a Cisco UCM deployment and has created the Meet-me number and ensured that it is in a partition accessible by all devices. Which two additional steps must the administrator perform? (Choose two.)
Update the softkey template on all phones to ensure that they contain the Meet-me softkey.
Refer to the exhibit.
The customer is troubleshooting an issue where users cannot dial the CMS SIP Route Pattern. The CMS URI they are attempting to dial is 7772002@cms.domain.local. Which IPv4 pattern must the customer enter to resolve the issue?
Refer to the exhibit.
A company needs to ensure that all calls are normalized to ♦ E164 format. Which configuration will ensure that the resulting digit string ♦14085554001 is created and will be routed to the E.164 routing schema?
Cisco SIP IP telephony is implemented on two floors of your company. Afterward, users report intermittent voice issues in calls established between floors. All calls are established, and sometimes they work well, but sometimes there is one-way audio or no audio. You determine that there is a firewall between the floors, and the administrator reports that it is allowing SIP signaling and UDP ports from 20000 to 22000 bidirectionally. What are two possible solutions? (Choose two.)
An engineer set up and successfully tested a TEHO solution on the Cisco UCM. PSTN calls are routed correctly using the IP WAN as close to the final PSTN destination as possible. However, suddenly, calls start using the backup local gateway instead. What is causing the issue?
A user reports that when they attempt to log out from the Cisco Extension Mobility service by pressing the Services button, they cannot log out. What is the most likely cause of this issue?
Refer to me exhibit.
A user cannot access Extension Mobility even after clicking the services button and selecting EM service. There is nowhere to place the username and password to sign In for this service. What Is the cause of the issue?
An SRST site must use pickup functionality on the Chicago remote site to allow the users to take incoming calls. The pickup command is configured under the call-manager-fallback section on the SRST router What are two results of that configuration? (Choose two.)