4A0-C01 Exam Dumps - Nokia NRS II Composite Exam

Go to page:

<< First
Prev
1
2
3
4
5
6
7
8
9
10
Next
Last >>

Question # 41

Which of the following is NOT required to configure an Alcatel-Lucent 7750 SR as a PE router running 6PE?

Configure BGP with the IPv6 address family.

Configure BGP to add IPv6 Explicit Null labels.

Configure a route policy to export IPv6 routes into BGP.

Configure the nexthop core router as a BGP peer.

Full Access

Question # 42

Which of the following options are used to configure an MPLS signaling type to be used on an SDP? (Choose 2)

configure service sdp sdp-id gre create

configure service sdp sdp-id create

Idp

Isp Isp-name

Full Access

Question # 43

What is the purpose of a T-LDP session?

It allows link LDP to be configured on the edge devices only.

It is used to signal the transport labels in the provider core.

It allows selective control over which devices are configured for LDP.

It is used to signal the service labels in the provider core.

Full Access

Question # 44

Consider a network that has four PE routers. If a customer wants a VPLS that has sites on only three of the PEs, how many mesh SDPs need to be configured for this service?

Full Access

Question # 45

Which of the following fields is NOT present in a GRE encapsulated VPN service packet?

DLC Header

Control Word

Transport Label

Service Label

Full Access

Question # 46

On an Alcatel-Lucent 7750 SR, what is the recommended approach for making sure that MTUs between a VPLS and its spoke IES termination match?

Set the service MTU of the VPLS to match the IES MTU.

Set the ip-mtu of the IES to match the service MTU of the VPLS.

Set the SDP MTU of the IES to match the SDP MTU of the VPLS.

Set the MTU of the IES's network port to match the service MTU of the VPLS.

Full Access

Question # 47

Consider an E-pipe service configured with SAP 1/1/1:5 and SAP 1/1/1:6.7. If the SAP 1/1/1:5 accepts an ingress frame, which of the following is TRUE?

The frame egresses 1/1/1:6.7 with an outer VLAN tag of 6 and inner tag of 7.

The frame is dropped at the egress SAP 1/1/1:6.7.

The frame egresses 1/1/1:6.7 with VLAN tag 5.

The frame egresses 1/1/1:6.7 with VLAN tag 6.

Full Access

Question # 48

Which of the following statements best describes an OSPF type 3 LSA?

An OSPF type 3 LSA is an intra-area LSA, generated by the ABR only when route summarization is configured.

An OSPF type 3 LSA is an inter-area LSA, generated by the ABR only when route summarization is configured.

An OSPF type 3 LSA is an inter-area LSA, generated by an ASBR to describe external routes.

An OSPF type 3 LSA is an inter-area LSA, generated by the ABR to describe a route to neighbors outside the area.

Full Access