Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

5V0-21.21 Exam Dumps - VMware HCI Master Specialist

Go to page:
Question # 9

An administrator is troubleshooting vSAN performance issues, and the performance diagnostics reports:

"There are errors seen in one or more physical NICs on one or more hosts."

Which two problems must be resolved to fix this issue? (Choose two.)

A.

A 25 Gb/s NIC needs to be installed.

B.

There are incompatible firmware and driver versions.

C.

There is an incorrectly set MTU.

D.

The vSAN version needs to be upgraded to 7.0.

E.

A firewall is blocking ports.

Full Access
Question # 10

A company hosts a vSAN 7 stretched cluster for all development workloads. The original sizing of a maximum of 250 concurrent workloads in the vSAN cluster is no longer sufficient and needs to increase to at least 500 concurrent workloads within the next six months.

To meet this demand, the original 8-node (4-4-1) cluster has recently been expanded to 16 nodes (8-8-1).

Which three additional steps should the administrator take to support the current growth plans while minimizing the amount of resources required at the witness site? (Choose three.)

A.

Add the new vSAN witness appliance to vCenter Server.

B.

Deploy a new large vSAN witness appliance at the witness site.

C.

Configure the vSAN stretched cluster to use the new vSAN witness.

D.

Deploy a new extra large vSAN witness appliance at the witness site.

E.

Upgrade the vSAN stretched cluster to vSAN 7.0 U1.

F.

Configure the new vSAN witness as a shared witness appliance.

Full Access
Question # 11

An 8-Node vSAN Stretched Cluster (4+4+1) with a single disk group has a policy with PFTT=1 (mirrored across sites) and SFTT=1/FTM Mirroring (Local Protection) configured.

The administrator has been alerted that there is a problem with the cluster. The following has been observed:

* The vSAN Witness Host is offline.

* Two disk failures on two hosts have occurred in the preferred site.

This has resulted in a critical production virtual machine’s vmdk becoming inaccessible.

Which step needs to be performed by the administrator to resolve the issue?

A.

Replace all failed disks on the preferred site.

B.

Replace the vSAN Witness Host

C.

Replace access to the existing vSAN Witness Host

D.

Replace only one failed disk on the preferred site.

Full Access
Question # 12

An architect intends to use the Primary Level of Failures To Tolerate (PFTT) to calculate the minimum number of required hosts for a vSAN cluster.

Which calculation model should be used?

A.

1 * PFTT + 1

B.

2 * PFTT + 2

C.

1 * PFTT + 2

D.

2 * PFTT + 1

Full Access
Question # 13

An architect collected the below technical requirements from the customer during a vSAN cluster design workshop:

* Maximize the vSAN datastore usable capacity.

* Deduplication and compression are required to help utilize available capacity efficiency.

* Ensure the highest level of resiliency wherever possible.

Which disk group configuration should the architect include in the design?

A.

One disk group per host, with one cache tier flash disk and four capacity tier flash disks.

B.

Two disk groups per host, each with one cache tier flash disk and four capacity tier flash disks.

C.

Two disk groups per host, each with one cache tier flash disk and six capacity tier flash disks.

D.

Two disk groups per host, each with one cache tier flash disk and six capacity tier magnetic disks.

Full Access
Question # 14

An administrator is planning to deploy workloads on a six node vSAN cluster, and all nodes are distributed equally across three racks.

Which action is required to ensure that the workload VMs remain compliant with the default vSAN policy after a complete rack failure?

A.

Add an additional rack with two hosts, and configure vSAN with four fault domains and FTT=1 (erasure coding).

B.

Add two additional hosts per rack, and configure vSAN with three fault domains and FTT=1.

C.

Add an additional host per rack, and configure vSAN with three fault domains and FTT=2.

D.

Add an additional rack with two hosts, and configure vSAN with four fault domains and FTT=1 (mirroring).

Full Access
Question # 15

An architect is tasked to design a VMware Horizon Solution with vSAN. The architect needs to use a solution to host the user’s profile shares in a highly available manner, and it must be guest OS independent.

Which solution will match these requirements?

A.

Cluster out of the box

B.

Cluster in a box

C.

NFS on vSAN

D.

iSCSI on vSAN

Full Access
Question # 16

Due to an update in their security requirements, an organization is no longer compliant because the metadata traffic between hosts in their vSAN cluster is not being encrypted.

Which step must be taken by the administrator to meet the new security requirements?

A.

Enable vMotion encryption on the vSAN cluster.

B.

Enable virtual machine encryption on the vSAN cluster.

C.

Enable Data-At-Rest Encryption on the vSAN cluster.

D.

Enable Data-In-Transit Encryption on the vSAN cluster.

Full Access
Go to page: