Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

5V0-21.21 Exam Dumps - VMware HCI Master Specialist

Go to page:
Question # 4

An administrator is tasked with sharing storage from one vSAN cluster to another vSAN cluster. SPBM management must be preserved end-to-end, and the policy must be applied by the source vSAN cluster which is storing the data. Both vSAN clusters are managed by the same vCenter server.

What should the administrator configure?

A.

NFS volumes on vSAN

B.

iSCSI targets on vSAN

C.

HCI Mesh on vSAN

D.

vVOLs on vSAN

Full Access
Question # 5

Which statement accurately describes the result when proper VM Storage Policy Affinity Rules on a stretched vSAN cluster are set?

A.

When a site is disconnected, the VM will lose access to its VMDK.

B.

When a site is disconnected, the VM will continue to have access to its VMDK.

C.

Bandwidth is unnecessarily sent across the inter-site link.

D.

Proper policies result in higher inter-site bandwidth utilization.

Full Access
Question # 6

An administrator has been tasked with enabling encryption for existing virtual machines on a vSAN cluster.

Which three prerequisites must be satisfied before completing the task? (Choose three.)

A.

Create an encryption storage policy

B.

Enable Data-In-Transit encryption first

C.

Enable that the virtual machines are powered on

D.

Verify if a role with privilege “Cryptographic operations.Encrypt new” is assigned

E.

Verify if a role with privilege “Cryptographic operations.Migrate” is assigned

F.

Establish a trusted connection with the KMS

Full Access
Question # 7

Upon checking the latency goal under vSAN performance diagnostics, the vSAN Administrator sees this message displayed:

The increase in latency in the vSAN stack might be beyond expected limits.

Which two root causes can be identified to help remediate the issue? (Choose two.)

A.

vSAN VMKemel portgroup is configured with the “Route based on IP hash” teaming policy

B.

vSAN encryption is enabled

C.

Large packet losses and retransmissions on the network layer

D.

Incorrect sizing of the disk groups capacity disks

E.

One or more disk groups are congested

Full Access
Question # 8

An administrator wants to check the performance metrics for the workloads and their virtual disks that are running on a vSAN cluster, but no statistical charts are displayed in the vSphere client.

Why is this behavior being seen?

A.

vSAN network diagnostic mode is not enabled.

B.

vSAN proactive tests haven’t been run yet.

C.

vSAN performance service is turned off.

D.

vSAN performance verbose mode is not enabled.

Full Access
Go to page: