FCSS_ADA_AR-6.7 Exam Dumps - FCSS Advanced Analytics 6.7 Architect

In the exhibit, the "Clear If" condition does not specify a condition for auto-clearing the incident. If an incident does not have a specific clear condition, it remains active until manually resolved or cleared by another process.

From the exhibit, we can determine the IP range that will be added to the CMDB and mapped to Customer E.

● The included IP range is 10.50.0.1 – 10.50.0.50.

● This means any device within this range (10.50.0.1 to 10.50.0.50) will be added to the CMDB.

10.50.0.1 → Falls within the included range (10.50.0.1 – 10.50.0.50) → Added to CMDB.

10.50.0.149 → Falls within the 10.50.0.1 – 10.50.0.50 range → Added to CMDB.

Group By automatically applies a COUNT aggregation.

When using Group By in FortiSIEM structured queries, it automatically applies a COUNT(*) function unless a different aggregation (such as SUM, AVG, or MAX) is specified. This helps summarize data by counting occurrences of grouped attributes.

Group By is applied to real-time and historical searches.

Grouping functions work in both real-time (live event monitoring) and historical (past event analysis) searches, making it useful for trend analysis, anomaly detection, and correlation.

In FortiSIEM, an agent’s status of "Running Inactive" indicates that the agent is installed and running but not actively sending data or has encountered a misconfiguration. The following reasons can cause this status:

1. The agent was registered incorrectly

If an agent was not registered properly, it might not establish a proper connection with the FortiSIEM system, resulting in an inactive status.

2. The agent is temporarily down

If the agent goes offline (e.g., due to system shutdown, network issues, or agent crash), it will show as inactive.

3. The template was not assigned

Agents require a template to function correctly. If no template is assigned, the agent cannot collect or process events, leading to an inactive state.

The incident shown in the exhibit indicates that a firewall detected malware but could not remediate it. The firewall identified the EICAR_TEST_FILE virus and logged the source IP (10.0.3.10) as the origin of the threat.

To remediate this, the administrator should take action at the network level, specifically using FortiOS to block the source IP address. The option "Run the block IP FortiOS 5.4" provides the ability to block traffic from the infected IP at the firewall level, effectively preventing further threats from that source.