H12-425 Exam Dumps - HCIP-Data Center Facility Deployment

( ) is the control component of doors in module data center.

After all the NetEco monitoring cables are connected, users need to check ( ).

By setting the mailbox parameters, the NetEco system will send an email to notify the user according to the set rules.

On the NetEco, the door name can’t be modified.

The NetCol5000-A25 kW supports light load dehumidification.

( ) can connect to the AI/DI port on the access actuator.

The height of the ECC800 collector is () U.

NetCol5000-Acompressor discharge high pressure alarm occurs, it may not that ().

FusionModule1000A series solution meets the TIER 4 requirements if it adopts 2N power supply and distribution system.

Which are the high reliability features of NetCol5000-C?

NetCol5000-A eliminate partial hot spots by in-row cooling.

DOD is the ratio of discharge battery capacity to the rated battery capacity, expressed as a percentage.

If IP21 component is configured, top cable routing is not supported for UPS5000-E.

Batteries in the same battery string must have the same capacity, same specifications and the same manufacturer.

For NetCol5000-A, if a meter detect that no current passes through the infrared humidifier, it indicates that the lamp is damage.

NetEco allows users to select alarm tones for different severities of alarms.

The input frequency range of the UPS5000-E is () Hz.

During filling refrigerant for NetCol5000-A, there is no need to put the refrigerant steel cylinder upside down on the electronic balance.

Every time NetCol5000-C startup, settings values need to be reset.

FusionModule1000 is an indoor prefabricated all in-one data center solution.

When excessive dust blocks up the air filter, the air filter differential pressure switch will generate alarm.

First time powering on UPS5000-E, make sure that the UPS main input switch, bypass switch, output switch, maintenance bypass switch and battery switch are all OFF

Depending on different layouts, the batteries can be deployed inside or outside FusionModule2000

When installing the power line on the UPS5000-E, if there are different sources on the main-lines and bypass, you need to remove the copper bars connected to the bypass and main lines first, and then connect the main circuit and bypass input respectively.

Whether the water distribution unit is equipped or not is based on installation scenarios

On the Current Alarm page of NetEco, filter criteria can’t set to search for the required alarms.

Modular Data Center is on-demand deployment, which avoids over-investment.

The UPS5000 option temperature and humidity sensor does not support cascading

For NetCol5000-A installation, the required time of preserving positive pressure is ( ) hours.

Two UPS2000-G with different software version can be connected in parallel.

Users can log in the WEBUI of the ( ) to monitor the module data center.

If a fire occurs in the FusionModule1000, the smoke detector and heat detector will send a fire alarm to the fire alarm control panel.

Which component can control the light and charge a pad in FusionModule2000?