HPE0-S59 Exam Dumps - HPE Compute Solutions

Go to page:

Question # 9

Refer to the exhibit.

Which statement about this logical interconnect group is true?

The master modules are located in the interconnect bays 2 and 5

For the given downlink speed, the maximum number of frames is reached

Both master modules are located in the same HPE Synergy frame

To use interconnect bay set 3, all compute nodes must be half-height

Full Access

Question # 10

Your customer plans to deploy VMware vSAN using D3940 Storage Modules.

Which statement about this solution is true?

The 12Gb SAS modules required for D3940 connectivity can only be installed in the first fabric.

To use the storage controller that will access D3940 storage modules, a second CPU must be installed.

For VMware vSAN deployment, all drives in the D3940 storage modules must be SSD drives.

All drives in the D3940 storage modules must formulate a single logical drive with RAID5 configured

Full Access

Question # 11

Which statement about port flap protection is true?

It can disable link aggregation groups or stacking ports that have gone down and come up in quick succession.

It allows an administrator to suppress excessive inbound multicast, broadcast, and DLF packets.

It allows configuration of hardware Layer 2 switching behavior of multicast traffic to optimize network resource usage.

It allows the creation of LACP groups on the upstream switch that span multiple HPE Synergy Virtual Connect modules.

Full Access

Question # 12

One of the administrators added some connections within a server profile that was created using a template. This server profile did not report inconsistency.

What is the most likely reason for this behavior?

The administrator removed FC connections that are not monitored by default.

Connections defined in the server profile are not monitored for compliance.

Consistency check for connections is set to Minimum or Not checked.

The server is in maintenance mode and does not report any issues.

Full Access

Question # 13

Your customer is trying to grow a VMware cluster using HPE OneView for VMware vCenter Server. They get an error and cannot proceed.

Which tool should you use to troubleshoot the problem?

HPE OneView interface to import an existing cluster using the hypervisor cluster profile functionality.

HPE OneView for VMware vCenter Server to verify if the server profile template is properly imported and registered.

vCenter Server to use the HPE OneView for VMware vCenter plugin to import the cluster for HPE OneView management.

iLO interface of a given HPE Synergy compute node to verify whether this node is registered within HPE OneView.

Full Access

Question # 14

Your customer plans to deploy VMware ESXi 7.0 U2, and they are looking for a hardware platform that will allow them to use up to 24 TB of physical memory.

Which HPE compute system meets the customer's requirements?

HPE Superdome Flex

HPE ProLiant DL380 Gen 10 Plus

HPE ProLiant DL580 Gen 10

HPE Synergy 480 Gen10 Plus

Full Access

Question # 15

Your customer plans to deploy HPE Superdome Flex and configure two nPars, each based on two chassis Which components must be included in the proposal to meet the customerâ€™s needs?

Rack Management Controller for nPar management

HPE Superdome Flex Grid licenses enabling connectivity between chassis

At least Tour HPE Persistent Memory DIMMs per nPar

One base chassis and three expansion chassis with licenses

Full Access