HPE2-T37 Exam Dumps - Using HPE OneView

Go to page:

Question # 9

Which operation can be performed using HPE OneView for VMware vCenter Server?

Remove a new node from an existing cluster

Create a new VMware cluster within vCenter Server

Configure VMware cluster properties tor HA and DRS

Create a new distributed switch for cluster connectivity

Full Access

Question # 10

Which statement about logical JBODs configured using KPE OneView and D3940 Storage Modules is true?

A logical JBOD lifecycle can be associated with a server profile lifecycle and drives can be securely erased.

A logical JBOD cannot be created during server profile creation and must be prepared in advance

Different types of the drives can be used within a logical JBOD as long as they have the same capacity

Logical JBOD functionality must be enabled on the Enclosure Group level by a storage administrator

Full Access

Question # 11

Refer to the exhibit.

Your customer wants to define a Logical Interconnect Group (UG) and set the redundancy of the master modules to highly available, but this option is not available. What is a possible reason?

There are not sufficient frames for highly available setup.

Some master modules only support a redundant setup.

Firmware on the master modules is too low to support highly available setup.

A dedicated license must be added to HPE OneView to enable this feature.

Full Access

Question # 12

Which component managed using HPE OneView can obtain an IP address from the subnet and address range defined in the HPE OneVlew settings?

Any supported HPE storage array

A Rack Management Controller

An iL0 in an HPE Synergy compute node

An iL0 in an HPE ProLiant server

Full Access

Question # 13

You want a server profile to be automatically applied when an HPE Synergy Compute Module is replaced.

Click the appropriate configuration option.

Full Access

Question # 14

Which statement about RoCE network restrictions is true?

RoCE networks require Virtual Connect SE 32Gb FC Modules.

RoCE networks cannot be configured when Virtual Connect modules are used.

RoCE networks are supported only when PVLANs are enabled.

RoCE networks are not supported with HPE BladeSystem

Full Access

Question # 15

Your customer would like to use the second mezzanine slot in an HPE Synergy 480 Genii compute node for dedicated FC connectivity. What is required to use the second mezzanine slot For the compute node?

A server profile template must be created.

All memory installed must be the maximum size.

An appropriate HPE OneView license is required.

A second processor must be installed.

Full Access