HPE6-A45 Exam Dumps - Implementing Aruba Campus Switching solutions

Refer to the exhibits.

Exhibit 1

Exhibit 2

Network administrators are alerted to high interface utilization on a switch by a management solution. They examine the utilization on the uplink interfaces several times an hour during problem times. The exhibit shows output typical of times of congestion. The administrators want to allocate bandwidth fairly and reduce congestion on the uplinks.

What could help meet these requirements?

Refer to the exhibit.

Network administrators set up PIM-DM to route multicast traffic from Server 1 to clients in VLAN 24. The multicasts are not active now, but the administrators want to determine which path the multicasts will take.

What should the administrators check to help them calculate this path?

Refer to the exhibit.

Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.

What is a typical issue that could cause this output?

Refer to the exhibits

Exhibit 1

Exhibit 2

Both Switch-1 and Switch-2 have an OSPF inter-area route to 10.2.0.0/16 with metric 10 in their IP routing table. Switch-3 has the default setting for ECMP. Based on the exhibits, what should the Switch-3 routing table display if the network operates as normal?

Refer to the exhibit.

A network administrator applies the ACL shown in the exhibit. Which source IP address does the myList ACL deny?

A network administrator configures connection rate filtering on interface 1 with the throttle action. Device 1 crosses the threshold and triggers the action.

What does the switch do?

A network uses MSTP and has AOS-Switches at the access layer. The company wants edge ports on the access layer switches to meet these criteria:

• They prevent all rogue switches that run STP, RSTP, or MSTP from connecting to the network.
• If a rogue switch connects and is then replaced by a proper endpoint, the port recovers automatically without IT staff involvement.

How should the network administrator set up the edge ports to meet these requirements?

Network administrators want to gain insight into network utilization, traffic patterns, and the types of applications in use across the network over the long term.

Which technology can help them achieve this goal?