Winter Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

Note! Following HPE6-A46 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

HPE6-A46 Exam Dumps - Delta - Implementing Aruba Campus Switching Solutions

Go to page:
Question # 4

Refer to the exhibits.

Exhibit 1

Exhibit 2

The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?

A.

Set the update source for the neighbor to the local loopback interface on each switch.

B.

Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.

C.

Enable the multihop option for the neighbor on each of the switches.

D.

Enable BGP on the interfaces that the switches use to reach each other.

Full Access
Question # 5

Which switches can be deployed in a mesh topology for backplane stacking?

A.

Aruba 2920 switches

B.

Aruba 2930F switches

C.

Aruba 2930M switches

D.

Aruba 3810 switches

Full Access
Question # 6

Refer to the exhibits.

Exhibit 1

Exhibit 2

Exhibit 1 shows the topology for the network. The network administrator sees the log entries shown in Exhibit 2. Which type of failure is indicated?

A.

A link between Switch-1 and Switch-2 went down. BFD detected the lost connectivity and behaved as expected.

B.

Graceful restart helper was not enabled on Switch-2, so BFD was unable to operate correctly, and the session was taken down.

C.

A hardware issue caused a unidirectional link; BFD detected the issue at Layer 2 and prevented a broadcast storm.

D.

BFD was set up incorrectly on Switch-2, so it caused Switch-2 to lose adjacency with Switch-1 rather than repair the session.

Full Access
Question # 7

Refer to the exhibits:

Exhibit 1

Exhibit 2

A network administrator at a university notices high utilization on links between the access layer and core. The output shown in the exhibit is characteristic of samples taken several times an hour during congestion. The administrator suspects file sharing and other unauthorized traffic, and decides to use an ACL to permit only HTTP, HTTPS, and a few other authorized types of traffic.

How can the administrator apply the ACL to address both the security and the congestion problem?

A.

as an inbound PACL on the link aggregations on the access switches

B.

as an inbound VACL on the student VLAN on Switch-1

C.

as an inbound PACL on the link aggregations on Switch-1

D.

as an inbound VACL on the student VLAN on the access switches

Full Access
Question # 8

Refer to the exhibits.

Exhibit 1

Exhibit 2

Switch-1 and Switch-2 lost IP connectivity with each other. They did not detect the issue for several seconds and caused a temporary traffic disruption. The administrations expected failover to the backup route through Switch-3 to occur in less than a second. The administrators restore the failed link and view the output on Switch-1, shown in the exhibit.

What should they do to create the expected behavior if connectivity is lost again?

A.

Lower the hello timer to a given range of times on each OSPF routing switch in VLAN 100

B.

Enable BFD in asynchronous mode on each OSPF routing switch in VLAN 100

C.

Manually configure the network type as point-to-point on each OPSF routing switch in VLAN 100

D.

Set a BFD echo source IP address on each OSPF routing switch in VLAN 100

Full Access
Go to page: