New Year Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

HPE6-A72 Exam Dumps - Aruba Certified Switching Associate Exam

Go to page:
Question # 25

What is the Link Layer Discovery Protocol?

A.

a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system

B.

a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4

C.

a standardized protocol for communicating directly-connected device information and capabilities.

D.

an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP

Full Access
Question # 26

Refer to the exhibit.

What does the command page result in?

A.

Starts an automatic page scrolling effect that pauses for a few seconds every 30 rows.

B.

Enables a terminal notification when a new debug event occurs for L2MAC events.

C.

Shows a new terminal window opening to allow typing while debugging occurs.

D.

Results in a page break to disable the default continuous scrolling In the console.

Full Access
Question # 27

Which two options are the Layer 3 Routing protocols? (Choose two.)

A.

BGP

B.

LLDP

C.

OSPF

D.

MPLS E. 802.3ad

Full Access
Question # 28

Review the exhibit.

As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.

Click on the interface (circled in green) where the VLAN tag will be removed.

Full Access
Question # 29

Which two statements accurately describe the features of NetEdit? (Choose two.)

A.

NetEdit can be used to configure and validate any third-party device that supports SSH and REST access.

B.

NetEdit includes trial licensing for up to 10 nodes.

C.

NetEdit can perform configuration and compliance validation.

D.

NetEdit supports viewing and editing multiple devices using a single deployment plan.

E.

NetEdit can run on a mobile device using Android or Apple IOS.

Full Access
Question # 30

Refer to the exhibit.

What configuration is needed in order for "show LLDP configuration" to show this output?

A.

none; LLDP is enabled by default on Aruba switches

B.

configuring LLDP both globally and on the interfaces

C.

enabling LLDP on the interfaces only

D.

configuring LLDP globally only

Full Access
Question # 31

Interface 1/1/1 is up

Admin state is up

Link transitions: 1

Description: TO_PC-1

Hardware: Ethernet, MAC Address: 00:11:22:33:44:55

MTU 1500

Type 1GbT

Full-duplex

qos trust none

Speed 1000 Mb/s

Auto-negotiation is on

Flow-control: off

Error-control: off

MDI mode: MDIX

VLAN Mode: access

Access VLAN: 1111

Which command will produce the above output?

A.

show interface vlan 1111

B.

show interface 1/1/1

C.

show interface gigabit 1/1/1

D.

show vlan 1111

Full Access
Go to page: