HPE6-A72 Exam Dumps - Aruba Certified Switching Associate Exam
Which two statements accurately describe stacking with Aruba switches? (Choose two.)
What are two available options as part of a DHCP offer message? (Choose two.)
Core(config)# user admin password
Core(config)# interface mgmt
Core(config-if-mgmt)# ip static 10.254.16.89/22
Core(config-if-mgmt)# default-gateway 10.254.19.129
Core(config)# ssh server vrf mgmt
Core(config)# https-server vrf mgmt
You are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings.
Which two steps are missing? (Choose two.)
Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)
What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)
What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)
Refer to the exhibit.
All four switches in the diagram have been configured with the region name "Aruba1".
What two other MSTP configurations must match for switches within the same MST region? (Choose two.)
Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)
Which two port characteristics must match between LAG interfaces? (Choose two.)
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
Refer to the exhibit.
What command (output shown above) gives the optics serial number and part number information?
Refer to the exhibit
Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?
Match each network protocol to the current default listening port and transport protocol. Not all answer will be used.
A screenshot of a computer
Description automatically generatedClick on the colored box that corresponds with the line that best represents Unicast traffic flow.
Refer to the exhibit.
The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches. What is the output of this command?
What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)
What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.
Diagram
Description automatically generatedWhich two statements accurately describe the features of NetEdit? (Choose two.)
Refer to the exhibit.
What configuration is needed in order for "show LLDP configuration" to show this output?
Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?