New Year Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

H12-322 Exam Dumps - Huawei Certified ICT Professional - Wireless Local Area Network- Planning and Optimizing Enterprise WLAN

Go to page:
Question # 25

In the WLAN bandwidth design, the average bandwidth of the access users decreases linearly with the increase of the user.

A.

True

B.

False

Full Access
Question # 26

Which of the following options are part of the lifecycle phase of a WLAN project operation?

A.

Planning

B.

Deployment

C.

Upgrade

D.

Operation and maintenance

E.

Troubleshooting

Full Access
Question # 27

In the WLAN security access authentication technology, which way is the air interface packet encrypted?

A.

MAC certification

B.

Portal authentication

C.

PSK certification

D.

Wireless 802.1x authentication

Full Access
Question # 28

What is the correct description of the indoor distribution type AP6310SN?

A.

The power splitter has multiple interfaces. When signals enter from any one interface, they are equally divided into multiple signal outputs.

B.

When the AP is at the center of the room division network, it is recommended to use a single power splitter for direct splitting.

C.

When the AP is at one end of the room division network and the coverage area is large, it is recommended to use a coupler for signal splitting.

D.

Power splitters and couplers cannot be used in the same network at the same time

Full Access
Question # 29

A three-story office needs to plan a WLAN. After the site survey is completed, the engineer decides to place three APs on each floor. The letter about the three floors.

Is the road planning correct?

A.

1, 6, 11 / 6, 11, 1 / 11, 1, 6

B.

1, 11, 6 / 6, 11, 1 / 11, 1, 6

C.

1, 6, 11 / 6, 1, 11 / 11, 1, 6

D.

11, 1, 6 / 1, 6, 11 / 6, 11, 1

Full Access
Question # 30

The maximum transmission power of indoor WLAN products stipulated by international standards is 100mw, which is equivalent to?

A.

1dBm

B.

10dBm

C.

20dBm

D.

30dBm

Full Access
Question # 31

The outdoor bridge backhaul needs to focus on confirming the installation of the AP at the node and paying attention to the transmission path between the nodes.

What is the correct statement about leaf nodes, aggregation nodes, and transmission paths?

A.

If the leaf node needs to be used for coverage, it is necessary to pay attention to the outdoor coverage of the survey.

B.

If there are multiple aggregation points, you need to confirm the location of each aggregation point. Each aggregation point also needs to confirm the AP installation location and power supply mode.

C.

There should be no obstructions or distances between the convergence points and leaf nodes. There are allowed between the relay nodes and the convergence points, relay nodes and leaf points.

Obstacle obstruction

D.

The transmission path is the path between the stations. In the site survey, it is necessary to confirm the distance between the connected nodes. The PMP mode needs to confirm the most between the links.

large angle

Full Access
Question # 32

In a certain room subsystem, using the AP9330DN, each incoming antenna can be set to a different channel to avoid co-channel interference.

A.

True

B.

Falses

Full Access
Go to page: