H12-811_V1.0 Exam Dumps - HCIA-Datacom V1.0 Exam

In Huawei’s VRP, the default preference value for OSPF routes is generally 10, but this value can be adjusted based on configuration requirements. Therefore, it is not necessarily always set to 10, as network administrators may alter the preference to prioritize different routes. This flexibility allows customization based on the network's specific routing needs​.

In VRP, to enter the configuration view for a specific OSPF area, the syntax [Huawei-ospf-1] area 0.0.0.0 is used. This command specifies Area 0 in the correct format (dotted decimal notation) as required by VRP, which supports OSPF multi-area configuration by designating specific area views​.

In one-arm routing (or router-on-a-stick) mode, a single physical link (with sub-interfaces) can carry traffic between multiple VLANs, reducing the number of physical links required. This approach minimizes cabling and port usage while still enabling inter-VLAN communication. However, it does not inherently reduce IP address usage, routing table entries, or the number of devices required​.

Detailed Explanation:DNS (Domain Name System) is responsible for translating human-readable domain names (like www.example.com ) into IP addresses, enabling devices to locate services on a network. (Reference: HCIA-Datacom Training Material, DNS Function and Protocol Overview)

Tracert (Traceroute) works by sending packets with progressively higher TTL (Time-to-Live) values, causing them to expire at each router along the path. When TTL expires, the router sends back an ICMP "Time Exceeded" message, which includes the source IP address of that router. This allows Tracert to record the IP addresses of each router on the path to the destination​.

Detailed Explanation:Layer 2 switches operate at the data link layer, handling frames based on MAC addresses. They maintain a MAC address table to record mappings between MAC addresses and interfaces, allowing efficient frame forwarding within the local network. (Reference: HCIA-Datacom Training Material, Layer 2 Switching and MAC Address Learning)

The default route preference on Huawei VRP places Direct routes at the highest priority, followed by Static routes, then RIP, and finally OSPF. Direct routes are most trusted as they represent directly connected networks, while OSPF, being a dynamic protocol with more administrative distance, is prioritized lower by default​.

Detailed Explanation:

• Option A: Incorrect. UDP (User Datagram Protocol) does not use SYN or ACK flags, as it is a connectionless protocol and does not establish a connection before data transfer. SYN and ACK flags are features of TCP (Transmission Control Protocol), which establishes connections using a three-way handshake. (Reference: HCIA-Datacom Training Material, Transport Layer Protocols)

• Option B: Incorrect. UDP is suitable for delay-sensitive traffic (such as video or voice) because of its low overhead. However, UDP does not have a sequence number field or support reassembly, as it does not guarantee packet order or reliability. (Reference: HCIA-Datacom Training Material, UDP Characteristics)

• Option C: Correct. TCP requires a three-way handshake to establish a connection and a four-way handshake to terminate it, involving SYN, ACK, FIN flags for reliability. (Reference: HCIA-Datacom Training Material, TCP Connection Establishment and Termination)

• Option D: Correct. The well-known port number range is defined as 0 to 1023, and these are reserved for widely used protocols such as HTTP, FTP, and DNS. (Reference: HCIA-Datacom Training Material, Port Numbering)