H12-811_V1.0 Exam Dumps - HCIA-Datacom V1.0 Exam

The Bridge ID, a combination of bridge priority and MAC address, is used to determine the root bridge in STP. The switch with the lowest Bridge ID becomes the root bridge. If bridge priorities are identical, the switch with the lowest MAC address is selected as the root bridge​.

An ARP (Address Resolution Protocol) packet includes several fields essential for mapping IP addresses to MAC addresses. The fields include:

Source Protocol Address: Identifies the IP address of the requesting device.

Source Hardware Address: Contains the MAC address of the source.

Hardware Type: Indicates the hardware type, typically Ethernet.

Operation Code: Specifies the operation (request or reply). These fields collectively allow devices to resolve IP addresses to physical MAC addresses, enabling direct communication within the local network​.

In the provided routing table, the router’s next hop for each destination indicates whether the destination is reachable directly or indirectly. For entries where the next hop is specified, the router forwards packets accordingly through the designated interface, as confirmed in the table output. This information is used to verify the forwarding behavior for each destination​.

Detailed Explanation:The 802.11ax standard, also known as Wi-Fi 6, supports theoretical speeds over 5 Gbit/s and is designed for high-efficiency wireless networking in dense environments. (Reference: HCIA-WLAN Training Material, IEEE 802.11 Standards)

The Forward Delay timer in STP helps prevent temporary loops by setting a delay for ports transitioning through Listening and Learning states before reaching the Forwarding state. This wait period ensures that all switches have updated topology information, reducing the risk of broadcast storms or loops​.

The VRP platform does not support configuration through FTP. Configuration methods typically include using a console port, Telnet, or SSH, allowing for direct access to the device configuration. FTP is generally used for file transfer, not direct configuration, and therefore is not a supported method for configuring a router​.

Static IP addressing for servers in campus network planning is crucial for maintaining stable network access to server resources. Static IPs ensure that critical devices like servers have fixed addresses, allowing for predictable network access and reducing potential IP conflicts, which enhances network reliability. This practice is endorsed in Huawei's guidelines for effective campus network design and is considered a best practice for managing servers on a network​.

Detailed Explanation:In a "one-armed routing" setup, a router with sub-interfaces can handle inter-VLAN routing by logically segmenting traffic within a single physical interface. In this configuration, each department (Administration and Finance) is assigned a different VLAN with separate sub-interfaces on Router R1.

In such a setup, communication between different VLANs (i.e., inter-VLAN routing) is handled by the router, even without Proxy ARP enabled. The router can directly route packets between the VLANs as it is aware of the different networks and performs Layer 3 forwarding based on the IP address of each VLAN's sub-interface.

Thus, even if ARP Proxy is disabled, devices in the Administration and Finance departments can communicate through the router because inter-VLAN routing takes place at Layer 3 without relying on ARP proxy functionality​​​.