H12-811_V1.0 Exam Dumps - HCIA-Datacom V1.0 Exam

Comprehensive Explanation: To prevent unauthorized changes to the router's configuration, the administrator can take several steps. Configuring an ACL to restrict management access ensures that only authorized users, such as the administrator, can log in to the router. Additionally, using AAA (Authentication, Authorization, and Accounting) allows the administrator to manage user permissions and control access to the router's functions based on user roles. Port-security is used for limiting MAC addresses on switch ports, and login privilege levels should be set appropriately but not limited to level 0, which restricts almost all actions.

Comprehensive Explanation: In STP, the switch with the lowest Bridge ID is selected as the root bridge. The Bridge ID consists of the bridge priority and the MAC address. In this case, the switch with the bridge priority of 4096 has the lowest Bridge ID, making it the root bridge. If two switches have the same bridge priority, the MAC address is used to break the tie, with the lower MAC address winning.

Detailed Explanation:The command forward-mode direct-forward is used to configure the AC to enable direct forwarding, meaning that the AP will forward user data packets directly to the network without tunneling them through the AC, improving efficiency by reducing the load on the AC​.

Routers can learn routes from various sources:

Static routes: Manually configured routes.

Direct routes: Routes to networks directly connected to the router.

Summary routes: Aggregated routes summarizing multiple networks, often used in routing protocols.

Dynamic routes: Routes learned via routing protocols like OSPF, RIP, or BGP. These sources contribute to the router's routing table, enabling it to forward packets to known destinations​.

Detailed Explanation:While a switch will typically forward a unicast frame based on its MAC address table, certain scenarios like port security or VLAN restrictions may prevent the frame from being forwarded even if a MAC entry exists. (Reference: HCIA-Datacom Training Material, MAC Address Table and Frame Forwarding)

Configuration Analysis:

The router has two DHCP pools (pool1 and pool2).

Interface Gi/0/0 is assigned the IP address 10.10.10.1/24 and is configured to use global DHCP.

Reasoning:

The IP address 10.10.10.1 indicates that the interface belongs to the 10.10.10.0/24 network segment.

DHCP assigns IP addresses based on the network of the interface. Therefore, the host will receive an IP address from pool1 (10.10.10.0/24).

The country-code command is used on an AC (Access Controller) to specify the country code, which aligns the wireless settings with local regulatory standards. Setting the correct country code ensures compliance with regional RF (Radio Frequency) regulations, such as frequency bands and transmission power limits​.