LEED-AP-BD+C Exam Dumps - LEED AP Building Design + Construction (LEED AP BD+C)

Makeup water meters, conductivity controllers and overflow alarms

According to the Water Efficiency Prerequisite for Indoor Water Use Reduction, cooling towers and evaporative condensers must be equipped with makeup water meters, conductivity controllers and overflow alarms to reduce water consumption and prevent water waste. These devices help monitor and control the water quality, flow rate and level of the cooling system, and alert the operators of any malfunctions or leaks.

Detailed Explanation:

ASHRAE 90.1-2010 Appendix G is the reference standard used for energy modeling in LEED projects. It establishes guidelines for baseline building performance and energy simulation comparisons, allowing project teams to demonstrate energy performance improvements relative to code-minimum buildings.

Detailed Explanation:

Preliminary energy modeling focuses on the building’s massing, orientation, thermal comfort ranges, and energy supply sources. Plug and process loads are typically omitted at this stage as they are highly variable and depend on specific occupant behavior and equipment usage. LEED focuses on the building’s core energy performance during preliminary analysis.

To achieve the Energy and Atmosphere (EA) Credit: Demand Response, a project must create a comprehensive plan for responding to a demand response event (D). This includes a strategy for reducing electrical load when a demand response event is triggered by the utility provider. The plan should outline actions for shifting or reducing energy use during peak demand times to support grid stability. Permanent reductions (A), submetering (B), and specific load shift reductions (C) are not required for this credit.

The make and model of fixtures is required in determining the baseline for the Water Efficiency Prerequisite, Indoor Water Use Reduction. This information is used to calculate the baseline water consumption of the building, which is then compared to the proposed water use to determine the percentage reduction.

Furniture is the only type of product that needs to be evaluated for both VOC content and VOC emissions in the LEED BD+C Low-Emitting Materials credit. Flooring, composite wood, and wet applied products only need to meet the VOC content requirements, while other types of products, such as ceilings, walls, thermal and acoustic insulation, and exterior applied products, only need to meet the VOC emissions requirements1.

The Water Efficiency Credit, Indoor Water Use Reduction aims to reduce indoor water consumption by installing water-efficient fixtures and fittings, such as faucets, showerheads, toilets, and urinals1. A commercial dishwasher that is ENERGY STAR® labeled or performance equivalent would help reduce the water use for dishwashing, which is one of the process water uses included in the credit calculation2. A standard garbage disposal would not reduce water use, but rather increase it. An electronic submeter at the domestic water supply pipe to the building would help measure and monitor water use, but not directly reduce it. An open-loop HVAC system that discharges potable cooling water to a nearby lake would waste a lot of water and potentially harm the environment.

According to the LEED v4 Reference Guide for Building Design and Construction, the project team must conduct a waste stream audit to identify the top five recyclable waste streams generated by the building and its occupants. The audit must cover a representative time period of a minimum of 24 hours, and must account for variations in the type and quantity of waste generated by different building uses and operations. The project team must then provide dedicated areas for the collection and storage of these materials for recycling. The project team must also provide dedicated areas for the collection and storage of batteries, mercury-containing lamps, and electronic waste, or demonstrate that a local program is in place to properly dispose of these materials.